I know that several people have made these before, including the missing Leegeddy, as well as apparantly JohnP. For you industrious cable makers out there, making these would be a great idea. Whenever a V3 pops up in the yard sale, with a right angle power cable, all of the immediate PMs are asking about the cable. From what I understand, the basic plug needs to be notched with a dremel, with the cable run through, and filled with the same epoxy that people use in making the shorty RA XLRs. A little strain relief/heat shrink and it should be good to go. I have a spare power plug if anyone is up for doing this, and will obviously be happy to pay for the work. You could probably sell quite a few here. Anyone up to the challenge?