0 Members and 2 Guests are viewing this topic.
Stand alone voltage for the MKE 2 Elements is 7.5V. Their current consumption is ca. 250 µA
Ran the hat rig again tonight at John Kadlecik and it turned out perfectly ran on PIP from MixPre6. I suppose these things don't like 9v. These things sound pretty dang good for $20
Here's a sample from the John K show the other night. Nothing done but normalize up to -1db.https://drive.google.com/open?id=1pptD2XOsvShDJWP9nxppn081kyB0K_VfHere's that sample with a mono Sennheiser e614 test run as a center channel:https://drive.google.com/open?id=10HoqrjVE12C4pLN4pfetRcxkSM_A853sBoth the MKE2s and e614 were in "test mode" as this was the first outing for the 614 and the second outing for the MKE2 rig - the first time ended with brickwalling using CA9100. MKE2s were in a hat on my table and the 614 was about 5 feet high PAS. I didn't expect these to be useable but they turned out pretty good IMO.
Quote from: beegar on February 28, 2019, 02:00:21 PMHere's a sample from the John K show the other night. Nothing done but normalize up to -1db.https://drive.google.com/open?id=1pptD2XOsvShDJWP9nxppn081kyB0K_VfHere's that sample with a mono Sennheiser e614 test run as a center channel:https://drive.google.com/open?id=10HoqrjVE12C4pLN4pfetRcxkSM_A853sBoth the MKE2s and e614 were in "test mode" as this was the first outing for the 614 and the second outing for the MKE2 rig - the first time ended with brickwalling using CA9100. MKE2s were in a hat on my table and the 614 was about 5 feet high PAS. I didn't expect these to be useable but they turned out pretty good IMO.Have you (or anyone else for that matter) measured the PIP voltage from a MP3?
Just in case this was not previously known, Sennheiser finally got back with me on confirming the MKE2 operating voltage.QuoteStand alone voltage for the MKE 2 Elements is 7.5V. Their current consumption is ca. 250 µA
I’m considering wiring these up to mini XLR jacks and having mics that can easily be disconnected from their cables to allow for easier storage, transport, and setup. Are there any obvious reasons to avoid this that I may be overlooking?