Taperssection.com
Gear / Technical Help => Cables => Topic started by: swordfish on September 01, 2009, 05:58:42 AM
-
Hi tapers,
I am planning to record the Magnolia Electric Co in the near future.
I know the are taper friendly and allow to tie into the SBD. Which cable should I bring allong to be able to connect.
I have a long chince cable with 1/8" miniplug that would work with my Korg or Edirol.
But I am not shure if the chinch will work with the SBD .
I am sure that question was asked before......
thanks in advance,
swordfish
-
all boards have a "tape out" , which is an RCA left/right pair. And even if its being used, its going into "something" that will also have outputs that are likely RCA.
so RCA > your decks required input...and you're golden.
some even have a s/pdif output, but neither of those would help you w/the Korg/Edirol (r44 not withstanding)
-
Check the stickied post at the top of the forum.
-
all boards have a "tape out" , which is an RCA left/right pair. And even if its being used, its going into "something" that will also have outputs that are likely RCA.
so RCA > your decks required input...and you're golden.
some even have a s/pdif output, but neither of those would help you w/the Korg/Edirol (r44 not withstanding)
I am golden since I have the required cable RCA - 1/8" mini plug.
Thanks,
SF
-
I wanna hear your meco pull when your done :) those guys are great!
Neil