Become a Site Supporter and Never see Ads again!

Author Topic: Setup of mics for stealthing  (Read 5196 times)

0 Members and 1 Guest are viewing this topic.

Offline Teen Age Riot

  • Trade Count: (5)
  • Taperssection Member
  • ***
  • Posts: 895
  • Gender: Male
Re: Setup of mics for stealthing
« Reply #15 on: January 26, 2005, 11:47:54 PM »
Another option that has not been mentioned yet, would be to make a stack tape by standing in line with one of the P.A. stacks, relatively close to the stage. That should give you less room reverb and possibly less crowd noise. I prefer the more up-front sound of stack tapes, and that's how I record 99% of the time when I'm stealthing, but tastes vary, of course...

Offline fandelive

  • Trade Count: (1)
  • Taperssection Member
  • ***
  • Posts: 480
  • I'm a llama!
Re: Setup of mics for stealthing
« Reply #16 on: January 27, 2005, 07:18:53 AM »
embarassed to ask,.... I'm not so familiar with that mic line. are these small omnis, or cardioids?

SP-BMC-xx are omnis. ("B" for binaural)
SP-CMC-xx are cardioids. ("C" for cardioid)

Mics : Sony ECM-717, MM-HLSC-1 (4.7k mod), SP-CMC-4 (at853), 2x DPA4060, 2x DPA4061
Battery box : SP-SPSB-6524 w/bass roll-off filter, MM-CBM-1
Preamp : Church Audio CA-9100
Recorders : Sony MZR-700PC, Edirol R-09HR, Tascam DR-2d

Offline spyder9

  • Trade Count: (82)
  • Needs to get out more...
  • *****
  • Posts: 13198
  • Gender: Male
  • "Are you Zman?"
    • My Archived shows
Re: Setup of mics for stealthing
« Reply #17 on: January 27, 2005, 09:53:19 AM »
BlueEyes17el,

SP-CMC-2 > SP-SPSB-6 > JB3.  I ran almost the exact same setup, except I was using Giant Squids mini cardioids.  Have your taped anything with this setup yet?  If you haven't, you may hear a small beeping noise in your recording.  The beep will be about every 10 seconds or so.  That'is from the hard drive spinning in the JB3.  You'll need a Denecke AD-20 mic preamplifier between the battery box and the JB3.  The preamp will raise the recording to line-level, which will eliminate the beep.

Just friendly advice based on experience.  Welcome to TS!  T+


thierryhenry

  • Guest
  • Trade Count: (0)
Re: Setup of mics for stealthing
« Reply #18 on: January 27, 2005, 11:28:50 AM »
don't be embarressed, heck a lot of guys on this board tape DMB ;)

Very true, ha.

By the way, Hanson butchered Radiohead's Optimistic...

Offline BlueEyes17el

  • Trade Count: (0)
  • Taperssection Newbie
  • *
  • Posts: 33
  • Gender: Female
Re: Setup of mics for stealthing
« Reply #19 on: January 27, 2005, 04:59:06 PM »
BlueEyes17el,

SP-CMC-2 > SP-SPSB-6 > JB3.  I ran almost the exact same setup, except I was using Giant Squids mini cardioids.  Have your taped anything with this setup yet?  If you haven't, you may hear a small beeping noise in your recording.  The beep will be about every 10 seconds or so.  That'is from the hard drive spinning in the JB3.  You'll need a Denecke AD-20 mic preamplifier between the battery box and the JB3.  The preamp will raise the recording to line-level, which will eliminate the beep.

Just friendly advice based on experience.  Welcome to TS!  T+



No I haven't taped yet. But I've listened to a bunch of recordings with the same setup, and there weren't any beeps. I should get the mics next week so I'll test them out at home.
SP-CMC-2 < SP-SPSB-6 < JB3

 

RSS | Mobile
Page created in 0.044 seconds with 30 queries.
© 2002-2024 Taperssection.com
Powered by SMF