Taperssection.com

Gear / Technical Help => Battery Boxes, Preamps, Mixers, ADCs, and Processors => Topic started by: discopanic1 on March 28, 2006, 12:08:17 PM

Title: M-Audio 410
Post by: discopanic1 on March 28, 2006, 12:08:17 PM

I just purchased the M-Audio 410 to use in DAT>PC conversion with the FireWire.  I also might try to use it as a pre in recording me and my bunch of friends playing music at the start to see what it is about.  I know it isn't gonna be anything close to the V3 but I wanna hear some fead back on the pre's in it.

Jesse Mc

Mk4/CMC6 > V3

Title: Re: M-Audio 410
Post by: zowie on March 28, 2006, 08:36:32 PM

They're reasonably quite and I find them inoffensive.  Bottom end a little soft.  Go have fun!

Title: Re: M-Audio 410
Post by: Chanher on March 29, 2006, 08:41:37 PM

I have not run a stock 410, but doug oade says the sounds isn't too far from a stock ua-5

http://www.oade.com/Tapers_Section/Forum/dcboard.php?az=show_mesg&forum=100&topic_id=1312&mesg_id=1320&page=

Title: Re: M-Audio 410
Post by: discopanic1 on April 02, 2006, 04:06:59 AM

This might actually be a good investment, only time and tapes will tell.  I'm going to set up my Mk4's running out of the 410 only into my Inspiron 6000 to test and see the pre's in it.  Then later in the testing I'm going to mic each instrument to run in and make a recording in that sense.