Taperssection.com
Gear / Technical Help => Remote Power => Topic started by: terrapinj on February 18, 2006, 01:19:44 PM
-
going to make a power cable from the mp-2 to a li-ion battery and need help figuring out which wire to solder to what pin on the mp-2 adapter. attached a photo below of the adapter. the mp-2 is tip positive.
thanks!
-
i also am going to be making one of these cables, i have that part too
-
Short one is tip, long is ring. Use a multimeter on its continuity setting to confirm.
-
Short one is tip, long is ring. Use a multimeter on its continuity setting to confirm.
actually just tested it with a multimeter, Brian is correct - as usual. Postive wire will be attached to the short one, negative to long.
Thanks for verifying Skalinder!