Become a Site Supporter and Never see Ads again!

Author Topic: different ways to setup my mics?  (Read 8936 times)

0 Members and 1 Guest are viewing this topic.

Offline caymanreview

  • Trade Count: (22)
  • Needs to get out more...
  • *****
  • Posts: 9849
  • Gender: Male
    • shows ive taped  that are in circulation
different ways to setup my mics?
« on: June 29, 2003, 10:40:38 PM »
i have the following and was wanting some input on different mic positions i would be able to use

akg c1000s
factory akg mic clips
sabrasom t bar

any input would be great

wrangler_n_space

  • Guest
  • Trade Count: (0)
Re:different ways to setup my mics?
« Reply #1 on: June 30, 2003, 12:54:03 PM »
Check out this site if you havent already.

http://www.dpamicrophones.com/eng_pub/

Offline caymanreview

  • Trade Count: (22)
  • Needs to get out more...
  • *****
  • Posts: 9849
  • Gender: Male
    • shows ive taped  that are in circulation
Re:different ways to setup my mics?
« Reply #2 on: June 30, 2003, 01:14:34 PM »
yeah i have looked at that site before

it just seems that with my sabra t-bar and the size of my c1000s that i am limited to the # of techniques i can use

would it be possible for me to run a XY with the sabra and c1000s?

my first large show will be dave @ umb bank pavillion - st louis. wont be extremely close but will be dead center or could tape off the delay towers if need be

what does everyone reccomend for that?


Offline F.O.Bean

  • Team Schoeps Tapir that
  • Trade Count: (126)
  • Needs to get out more...
  • *****
  • Posts: 40690
  • Gender: Male
  • Taperus Maximus
    • MediaFire Recordings
Re:different ways to setup my mics?
« Reply #3 on: June 30, 2003, 03:37:16 PM »
you can do XY only w/ a riser on one side of yer tbar....sonicsense has risers that act as quick release also...for 9 bucks.....you could take them off in a snap and run pretty much any mic conf..... ;) 8)

bean
Schoeps MK 4V & MK 41V ->
Schoeps 250|0 KCY's (x2) ->
Naiant +60v|Low Noise PFA's (x2) ->
DarkTrain Right Angle Stubby XLR's (x3) ->
Sound Devices MixPre-6 & MixPre-3

http://www.archive.org/bookmarks/diskobean
http://www.archive.org/bookmarks/Bean420
http://bt.etree.org/mytorrents.php
http://www.mediafire.com/folder/j9eu80jpuaubz/Recordings

Offline caymanreview

  • Trade Count: (22)
  • Needs to get out more...
  • *****
  • Posts: 9849
  • Gender: Male
    • shows ive taped  that are in circulation
Re:different ways to setup my mics?
« Reply #4 on: June 30, 2003, 03:38:54 PM »
thanks bean

did you get my pm from earlier

finally got that show i owe you burnt ;D

wrangler_n_space

  • Guest
  • Trade Count: (0)
Re:different ways to setup my mics?
« Reply #5 on: June 30, 2003, 03:38:58 PM »
I ran xy a few times when i had c1000s.
I had the sabr som shock mounts though. I just turned on upside down and angled them at 90 degrees with the ends directly over each other.

Offline caymanreview

  • Trade Count: (22)
  • Needs to get out more...
  • *****
  • Posts: 9849
  • Gender: Male
    • shows ive taped  that are in circulation
Re:different ways to setup my mics?
« Reply #6 on: June 30, 2003, 03:42:55 PM »
nice touch, never though about that ;D 8)

Offline caymanreview

  • Trade Count: (22)
  • Needs to get out more...
  • *****
  • Posts: 9849
  • Gender: Male
    • shows ive taped  that are in circulation
Re:different ways to setup my mics?
« Reply #7 on: June 30, 2003, 03:46:41 PM »
how much of a difference would there be in sound quality with one side of my sabra turned upside down, there would be almost 6" beetween the mics...

would that affect my sound alot, or should i just go buy the riser?

Offline Wes

  • Trade Count: (0)
  • Taperssection Member
  • ***
  • Posts: 720
  • Gender: Male
Re:different ways to setup my mics?
« Reply #8 on: June 30, 2003, 03:54:03 PM »
I'm not 100% sure I understand your question, but if you are referring to vertical displacement.  6" will not have an audible effect.
" Radio Shack md440zrs>high pass filter>whopper a>d "

wrangler_n_space

  • Guest
  • Trade Count: (0)
Re:different ways to setup my mics?
« Reply #9 on: June 30, 2003, 03:56:16 PM »
It never affected mine. I think as long as there are are on vertical plane with the caps aligned they should be ok.

Offline mirth

  • Trade Count: (0)
  • Needs to get out more...
  • *****
  • Posts: 2508
  • Gender: Male
  • Les Hommes Savvent Pourquois
Re:different ways to setup my mics?
« Reply #10 on: June 30, 2003, 04:03:54 PM »
I've ran XY with my C1000s & had the mic caps touching each other.... Turn the sabra bar so its going vertically, take one of the mic clips & rotate it 1/6th the way around the bar to the left (its hex shaped) and proceed to get your microphones set up at 90 deg. I don't have my mics with me but I believe that you need to turn the clips so the silk screening is towards the outsides of the Tbar (one facing left the other to the right).

I can prolly dig up some photos I took later tonite if you want.

I'd assume that setting up for DIN would be identical except for where on the mic bodies you attach the clips.

I've also set up my sabra for ORTF...
Governor Jim McGreevey was equally disturbed about the upcoming population increase. "New Jersey cannot support all of these wookies," he said. "For starters, we don't have nearly enough kindbud. At best, we can muster up a Q.P. of some beasties, but we've not a dime-bag more."

Offline caymanreview

  • Trade Count: (22)
  • Needs to get out more...
  • *****
  • Posts: 9849
  • Gender: Male
    • shows ive taped  that are in circulation
Re:different ways to setup my mics?
« Reply #11 on: June 30, 2003, 06:13:43 PM »
pics would be great mirth

thanks alot for the info so far guys

cpclark

  • Guest
  • Trade Count: (0)
Re:different ways to setup my mics?
« Reply #12 on: June 30, 2003, 11:40:31 PM »
ive been runnin c1000's for about 7 months now, and have tried many techniquest with the same equipment, except i have shockmounts, ive like NOS and XY work the best, i have a picture to if you contact me off board.

Offline mirth

  • Trade Count: (0)
  • Needs to get out more...
  • *****
  • Posts: 2508
  • Gender: Male
  • Les Hommes Savvent Pourquois
Re:different ways to setup my mics?
« Reply #13 on: June 30, 2003, 11:57:38 PM »
Here's an ORTF setup...
Governor Jim McGreevey was equally disturbed about the upcoming population increase. "New Jersey cannot support all of these wookies," he said. "For starters, we don't have nearly enough kindbud. At best, we can muster up a Q.P. of some beasties, but we've not a dime-bag more."

Offline mirth

  • Trade Count: (0)
  • Needs to get out more...
  • *****
  • Posts: 2508
  • Gender: Male
  • Les Hommes Savvent Pourquois
Re:different ways to setup my mics?
« Reply #14 on: July 01, 2003, 12:00:18 AM »
another ORTF
Governor Jim McGreevey was equally disturbed about the upcoming population increase. "New Jersey cannot support all of these wookies," he said. "For starters, we don't have nearly enough kindbud. At best, we can muster up a Q.P. of some beasties, but we've not a dime-bag more."

 

RSS | Mobile
Page created in 0.069 seconds with 43 queries.
© 2002-2024 Taperssection.com
Powered by SMF