Become a Site Supporter and Never see Ads again!

Author Topic: Pipsqueak Battery & Charger  (Read 1917 times)

0 Members and 1 Guest are viewing this topic.

Offline gormenghast

  • Trade Count: (46)
  • Taperssection Member
  • ***
  • Posts: 856
  • Gender: Male
Pipsqueak Battery & Charger
« on: February 15, 2025, 02:32:58 PM »
I have a Pipsqueak that needs a battery and charger.  I see on Naiant’s website the battery type and who to buy from, but I need a charger for it as well. Any suggestions?   I did email Jon last week and haven’t heard from him yet.

Thanks. 
A lot of people run a race to see who is the fastest. I run to see who has the most guts, who can punish himself into exhausting pace, and then at the end, punish himself even more.

Offline youngsbest

  • Trade Count: (0)
  • Taperssection Newbie
  • *
  • Posts: 25
Re: Pipsqueak Battery & Charger
« Reply #1 on: February 24, 2025, 12:06:10 PM »
The supplied charger is LPS  PSM03A-090.  The output is 9v 300ma.  Hopefully Jon can tell you where to get one.  But I don't see why any 9v power supply wouldn't work?  However you'd need to put a 3.5mm stereo jack on to connect to the Pipsqueak.  The tip is positive, the ring not connected and ground is ground (obs)

Offline gormenghast

  • Trade Count: (46)
  • Taperssection Member
  • ***
  • Posts: 856
  • Gender: Male
Re: Pipsqueak Battery & Charger
« Reply #2 on: February 25, 2025, 03:58:55 PM »
The supplied charger is LPS  PSM03A-090.  The output is 9v 300ma.  Hopefully Jon can tell you where to get one.  But I don't see why any 9v power supply wouldn't work?  However you'd need to put a 3.5mm stereo jack on to connect to the Pipsqueak.  The tip is positive, the ring not connected and ground is ground (obs)

Thank you for the info.  Jon replied to an email and said he would sell me one. 
A lot of people run a race to see who is the fastest. I run to see who has the most guts, who can punish himself into exhausting pace, and then at the end, punish himself even more.

 

RSS | Mobile
Page created in 0.027 seconds with 26 queries.
© 2002-2025 Taperssection.com
Powered by SMF