Become a Site Supporter and Never see Ads again!

Author Topic: Recorders paired with V3  (Read 1964 times)

0 Members and 1 Guest are viewing this topic.

Offline rocksuitcase

  • Trade Count: (3)
  • Needs to get out more...
  • *****
  • Posts: 7651
  • Gender: Male
    • RockSuitcase: stage photography
Re: Recorders paired with V3
« Reply #15 on: May 31, 2022, 11:45:43 AM »
Does the V3 Mic inputs run hot?

I have a Shure fp24 and need attenuators to use it for anything louder than acoustic guitar unamplified.

I have run both a MixPre and a V3..  and nothing that I have encountered runs as hot as a MixPre.
YMMV.
I second this. kindms mix-pre ran hot as hell. (but was the BEST small footprint pre I used with the M10)
music IS love

When you get confused, listen to the music play!

Mics:         AKG460|CK61|CK1|CK3|CK8|Beyer M 201E|DPA 4060 SK
Recorders:Marantz PMD661 OADE Concert mod; Tascam DR680 MKI

Offline kindms

  • Trade Count: (6)
  • Needs to get out more...
  • *****
  • Posts: 5773
    • The Breakfast
Re: Recorders paired with V3
« Reply #16 on: May 31, 2022, 05:49:48 PM »
I use my HDP2 when using the V3.

the HDP2 in my experience locks on to whatever digi signal you throw at it w/o complaints but certainly not small

I considered going a raspbery pi solution for small form factor and SPDIF. with a touch display but didnt pursue it. you could probably get an optical connector with a pi as well. Small and most of them run just fine on regular 5vUSB
AKG c426, AKG414 XLS/ST, AKG ck61, ck22, >nBob colettes >PFA > V3, SD MixPre >  TCM-Mod Tascam HDP2, Sony M10
Little Bear tube Pre >Outlaw Audio 2200 Monoblocks > VR-2's

 

RSS | Mobile
Page created in 0.028 seconds with 24 queries.
© 2002-2022 Taperssection.com
Powered by SMF