Become a Site Supporter and Never see Ads again!

Author Topic: Order of applied effects in the remastering process  (Read 1715 times)

0 Members and 1 Guest are viewing this topic.

Offline voltronic

  • Trade Count: (34)
  • Needs to get out more...
  • *****
  • Posts: 3624
Re: Order of applied effects in the remastering process
« Reply #15 on: September 24, 2022, 07:30:56 AM »
Recently upgraded to Izotope RX 10, and finally trying to figure it out.

In general, I think I'll use it to:
-reduce hum
-deal with quiet music / loud clapping issues
-wind
-breathing on the mics

I'm sure there are a million other things I can do with it, but trying to keep it simple to start.

For things like de-click, or using the repair assistant, a few questions:
-does it matter what order you use them in?
-do you apply to only isolated areas of the waveform (around the loud clapping, for instance) or just broadly to the entire file?

Any other useful/easy ideas to get started with?

I only recently upgraded to 9 and then 10 right after, so I've never tried Repair Assistant.

My typical RX workflow:

1. Normalize to -0.2 dB (I know this may sound odd to do first, but my 32-bit float files are often very low in level)
2. Spectral Repair to get rid of any random audience noises I want out of there
3. De-Click to reduce applause according to these steps. I only do this if the clapping is louder than the music; otherwise I leave it alone.
4. Spectral Denoise to reduce steady-state noise (for me, usually HVAC). I use the Highest Quality preset, Learn from the cleanest section I can find, and start with a reduction level of 6.0 and preview while adjusting it up or down until the noise is reduced to my liking but the music is unaffected. Toggling the "output noise only" box on and off while listening is critical to make sure you're not removing musical things. It takes some practice to get this right.
5. Normalize again if peaks were reduced by De-Click or other processes.
6. Export at original depth and rate.

Level adjustments and Spectral Denoise are applied to the entire concert. Everything else is only applied to the affected area.

I have tried De-Hum, but it does not do much of anything for the background noise in my recordings. I imagine it works well for loud oscillating lights or PA hum, but those aren't usually things I run into. Spectral Denoise continues to be the magic wand for cleaning up all of my concerts.
DPA 4061 ~ Line Audio CM3 ~ Naiant X-Q ~ AT 853  |  Naiant PFAs ~ Shure FP24  |  Zoom F6 ~ Sony PCM-M10
MOTU M2 ~ KRK Rokit RP5 ~ Sennheiser HD 650 ~ Etymotic ER4XR  |  iZotope RX ~ Reaper ~ foobar2000 (SoX linear)


Team Line Audio

Offline detroit lightning

  • Trade Count: (10)
  • Taperssection Member
  • ***
  • Posts: 734
Re: Order of applied effects in the remastering process
« Reply #16 on: September 24, 2022, 09:32:03 AM »
Thanks Voltronic!

 

RSS | Mobile
Page created in 0.029 seconds with 25 queries.
© 2002-2022 Taperssection.com
Powered by SMF