Become a Site Supporter and Never see Ads again!

Author Topic: Powering (2) 6 volt V-2's with a single 10-14-88 14 volt LI Battery  (Read 1687 times)

0 Members and 1 Guest are viewing this topic.

Offline waltmon

  • Trade Count: (14)
  • Needs to get out more...
  • *****
  • Posts: 2043
  • Gender: Male
Gumbino built me the super phatty power cable with dual chopped 4 pin XLR's....in theory, I think it will be safe to power these up one at a time.Or should I turn them both on  and the connect the cable...

  I know the v-2's can handle 12 volts plus or minus...

   Any opinions?
KM140's, KM150's, U89's, Mixpre-10T II, 788T, F3

CA-14 > UBB > Tascam DR-2D

1 pound non-sequential $50.00 bills

Offline waltmon

  • Trade Count: (14)
  • Needs to get out more...
  • *****
  • Posts: 2043
  • Gender: Male
Re: Powering (2) 6 volt V-2's with a single 10-14-88 14 volt LI Battery
« Reply #1 on: June 02, 2008, 06:34:53 PM »
bump for input, please.
KM140's, KM150's, U89's, Mixpre-10T II, 788T, F3

CA-14 > UBB > Tascam DR-2D

1 pound non-sequential $50.00 bills

 

RSS | Mobile
Page created in 0.06 seconds with 30 queries.
© 2002-2024 Taperssection.com
Powered by SMF