Become a Site Supporter and Never see Ads again!

Author Topic: Problem with my JB3 shutting down ...  (Read 2551 times)

0 Members and 1 Guest are viewing this topic.

Offline corvonero

  • Trade Count: (0)
  • Taperssection Newbie
  • *
  • Posts: 3
Problem with my JB3 shutting down ...
« on: December 26, 2005, 09:43:30 AM »
I searched the JB3 faq but could find an answer to my problem, hope someone out there can help me.
I taped a few shows with my JB3 (let's say 20+) and on some occasions i had a problem with my JB3 shutting down in the midst of the recording.
Let me say that i had my key-lock on to prevent shutting down problems, and also i'm using two batteries so power shortage is not the problem.
I usually keep my JB3 in a case logic bag with just the mic cable coming out under my t-shirt (have to stealth tape here in Italy) and i must say the bag is really full and tight with my JB3 and my preamp, so the best explanation i could come up with is that the JB3's internal heat has little or no way of attenuate and the JB3 shuts down for heat prevention.
Another thing i tought to be possible was that the preamp batteries were dead and the JB3 was shutting down after not receiving signal for a few minutes (this happened to me during a Mule show) but in subsequent times i had the chance to verify the preamp was not the problem.
Is this possible? Has anybody of you guys ever come up with such a problem?
I'm using the latest firmware release (can't remember the number) and i'm using the default settings that firmware has.

Thanks in advance for your help, and sorry for my bad english

Lorenzo

Offline leehookem

  • Trade Count: (3)
  • Needs to get out more...
  • *****
  • Posts: 4439
  • Gender: Male
    • Texas Tapers
Re: Problem with my JB3 shutting down ...
« Reply #1 on: December 26, 2005, 10:46:35 AM »
JB3's have a problem with heat.  They shut down easily.  Try keeping it away from the preamp, and keep the battery covers off the JB3.  That will help a little.
www.texastapers.org


AKG c480b ck61/ck63 > Tascam DR-70D
Oade ACM Marantz PMD-671
AKG ck61/63 > NBob Actives > Naiant PFA > Tascam DR-70D
Oade ACM Marantz PMD-671
Audiophile 2496 > Mytek Stereo96 DAC > Sony MDR-7506
Dual 1229 > Marantz 2270 > Kimber Kables > Cerwin Vega VS120

Canon Rebel XSi, EF 50 mm f/1.8, EF-S 18-55mm f/3.5-5.6 IS

Offline F.O.Bean

  • Team Schoeps Tapir that
  • Trade Count: (126)
  • Needs to get out more...
  • *****
  • Posts: 40690
  • Gender: Male
  • Taperus Maximus
    • MediaFire Recordings
Re: Problem with my JB3 shutting down ...
« Reply #2 on: December 26, 2005, 12:04:23 PM »
JB3's have a problem with heat.  They shut down easily.  Try keeping it away from the preamp, and keep the battery covers off the JB3.  That will help a little.

qft
Schoeps MK 4V & MK 41V ->
Schoeps 250|0 KCY's (x2) ->
Naiant +60v|Low Noise PFA's (x2) ->
DarkTrain Right Angle Stubby XLR's (x3) ->
Sound Devices MixPre-6 & MixPre-3

http://www.archive.org/bookmarks/diskobean
http://www.archive.org/bookmarks/Bean420
http://bt.etree.org/mytorrents.php
http://www.mediafire.com/folder/j9eu80jpuaubz/Recordings

Offline corvonero

  • Trade Count: (0)
  • Taperssection Newbie
  • *
  • Posts: 3
Re: Problem with my JB3 shutting down ...
« Reply #3 on: December 27, 2005, 05:53:21 PM »
JB3's have a problem with heat.  They shut down easily.  Try keeping it away from the preamp, and keep the battery covers off the JB3.  That will help a little.

Thanks for your advice, will try to do like that  ;)

Lorenzo

Offline jkoch

  • Trade Count: (0)
  • Taperssection Member
  • ***
  • Posts: 855
  • Gender: Male
  • groovy!
Re: Problem with my JB3 shutting down ...
« Reply #4 on: January 01, 2006, 06:37:28 PM »
indeed. if the jb3 is in a bag up against a pre (in my case an mp2) it may overheat, especially if the bag is closed
Schoeps MK4s > active cables > NBox+ > Edirol R-09HR

Offline willndmb

  • Trade Count: (17)
  • Needs to get out more...
  • *****
  • Posts: 6792
  • Gender: Male
Re: Problem with my JB3 shutting down ...
« Reply #5 on: January 02, 2006, 08:10:17 PM »
you can also pop off the faceplate to add afew "vents" on the front
Mics - AKG ck61/ck63 (c480b & Naiant actives), SP-BMC-2
XLR Cables - Silver Path w/Darktrain stubbies
Interconnect Cables - Dogstar (XLR), Darktrain (RCA > 1/8) (1/8 > 1/8), and Kind Kables (1/8f > 1/4)
Preamps - Naiant Littlebox & Tinybox
Recorders - PCM-M10 & DR-60D

Offline Karl

  • Trade Count: (0)
  • Taperssection Member
  • ***
  • Posts: 377
Re: Problem with my JB3 shutting down ...
« Reply #6 on: January 03, 2006, 03:28:55 PM »
fwiw, I've worked with two jb3's and have had no problem with heat.  And this is tested in an Arizona (Phoenix) summer.  Not all jb3's have the same heat properties I would assume.
My portable rig:

AT853>Zoom F6

Offline corvonero

  • Trade Count: (0)
  • Taperssection Newbie
  • *
  • Posts: 3
Re: Problem with my JB3 shutting down ...
« Reply #7 on: January 09, 2006, 09:38:31 AM »
Thanks everybody for your help and suggestions, i should be taping a couple of shows at the end of the month and will try to see how it goes.

Lorenzo

 

RSS | Mobile
Page created in 0.08 seconds with 34 queries.
© 2002-2024 Taperssection.com
Powered by SMF