Become a Site Supporter and Never see Ads again!

Author Topic: iRiver H120 CF Mod Attempt - Success!  (Read 160853 times)

0 Members and 1 Guest are viewing this topic.

Offline amgod

  • Trade Count: (0)
  • Taperssection Newbie
  • *
  • Posts: 4
Re: iRiver H120 CF Mod Attempt - Success!
« Reply #240 on: July 20, 2009, 11:50:56 AM »
i also can report a success  ;D

i used arnis manual using a 8gb sandisk extreme which will be recognized as a



was kinda scary though. it was booting, could access the drive but playing any song caused a crash. did some resets, cleared settings and somehow it worked in the end  ;D works very smooth and nicely now :)

the player enjoyed a decent diet. while it was 168g before, its a lightweight of 130g now.

btw which rockbox v3 compatible wps are available?
« Last Edit: July 20, 2009, 12:29:46 PM by amgod »

Offline slightlys

  • Trade Count: (4)
  • Taperssection Member
  • ***
  • Posts: 904
  • Gender: Male
Re: iRiver H120 CF Mod Attempt - Success!
« Reply #241 on: August 04, 2009, 09:51:46 PM »
On an already rockboxed H120 can I copy the rockbox dir to my pc. Install the CF card  connect to PC via USB copy rockbox dir to CF card restart and bingo mod complete?

depends which bootloader is installed, the version number is shown at startup (right after switching it on)
Sweet I updated to the latest firmware 3.3 and bootloader 7 pre 4. So now i can install the cf card and copy the rockbox dir to the card. Correct?
Peluso CEMC6>Bumblebee MiAGi-II silver clad cables>Bm2p+ mod UA-5 >  OCM R-44

Offline EarlyMorningRain

  • Trade Count: (7)
  • Needs to get out more...
  • *****
  • Posts: 2779
Re: iRiver H120 CF Mod Attempt - Success!
« Reply #242 on: August 04, 2009, 11:54:25 PM »
yepper!    ;D

(I hope)

Offline amgod

  • Trade Count: (0)
  • Taperssection Newbie
  • *
  • Posts: 4
Re: iRiver H120 CF Mod Attempt - Success!
« Reply #243 on: August 17, 2009, 09:38:52 AM »
i just plugged in the charger and the green light is alight. is that ok? does it turn off when its done?

Offline taylordb

  • Trade Count: (0)
  • Taperssection Member
  • ***
  • Posts: 256
Re: iRiver H120 CF Mod Attempt - Success!
« Reply #244 on: August 18, 2009, 05:52:02 AM »
Yes, off when charged.

Offline gd420mj

  • Trade Count: (0)
  • Taperssection Newbie
  • *
  • Posts: 46
  • Gender: Male
  • Live Music is Better
Re: iRiver H120 CF Mod Attempt - Success!
« Reply #245 on: August 27, 2009, 01:16:23 AM »
I don't know if this was asked, its late and I just can't read anymore.

Can this be done in the other direction? i.e. A device that normally uses CF, replace the CF with a HD. (any size, preferably 2.5")?

I have searched all over but all I come up with is CF to IDE (replacing HD with CF). I want to replace a CF with HD.....i know, sounds strange, but I'd like to try.

I have an 80GB JB3 that i'd like to replace. I have been eyeing up the PMD660. I just don't like the portable media. I have 80BG in the JBE, if I could make an adapter to plug into the CF slot and feed the HD, i'd be happy and be able to record long weekends. The entire weekend. I'd hate to invest in lots of CF's or have a laptop on site to transfer to. I am not worried about battery power. The mypowers look like they can handle anything.

Sorry if the wrong place to ask here, I just cannot find any info. And you are all so knowledgeable.  But I don't see why it can't be reversed. and for cheap. THe interfaces are so similar.

Thanks in advanced.
« Last Edit: August 27, 2009, 01:19:13 AM by gd420mj »
superlux SMK-H8K>UA5> M10
or
superlux SMK-H8K>tascam DR-100
or
WM-61A > battery box > PCM-M10

Offline sunjan

  • Trade Count: (0)
  • Needs to get out more...
  • *****
  • Posts: 2006
  • Gender: Male
  • Taping since 1988, 28 years of fine recordings...
    • Just a handful of stuff I put on etree
Re: iRiver H120 CF Mod Attempt - Success!
« Reply #246 on: August 27, 2009, 02:44:50 AM »
Can this be done in the other direction? i.e. A device that normally uses CF, replace the CF with a HD. (any size, preferably 2.5")?
It should be possible in theory, but it doesn't make much sense, given the low cost of solid state media.

You'd either have make it a DIY soldering project, or you can start out with a CF>IDE adapter and add two male/female pin converters on each end.
It's going to be a lot bulkier than a CF card, so your main problem will be fitting this contraption inside a recorder that was designed for just a CF card to start with. Go figure...  8)
Mics: A-51s LE, CK 930, Line Audo CM3, AT853Rx (hc,c,sc),  ECM 121, ECM 909A
Pres: Tinybox, CA-9100, UA5 wmod
Recorders: M10, H116 (CF mod), H340, NJB3
Gearbag: High Sierra Corkscrew
MD transfers: MZ-RH1. Tape transfers: Nak DR-1
Photo rig: Nikon D70, 18-70mm/3.5-4.5, SB-800

Offline EarlyMorningRain

  • Trade Count: (7)
  • Needs to get out more...
  • *****
  • Posts: 2779
Re: iRiver H120 CF Mod Attempt - Success!
« Reply #247 on: August 27, 2009, 02:19:50 PM »
I don't know if this was asked, its late and I just can't read anymore.

Can this be done in the other direction? i.e. A device that normally uses CF, replace the CF with a HD. (any size, preferably 2.5")?

I have searched all over but all I come up with is CF to IDE (replacing HD with CF). I want to replace a CF with HD.....i know, sounds strange, but I'd like to try.

I have an 80GB JB3 that i'd like to replace. I have been eyeing up the PMD660. I just don't like the portable media. I have 80BG in the JBE, if I could make an adapter to plug into the CF slot and feed the HD, i'd be happy and be able to record long weekends. The entire weekend. I'd hate to invest in lots of CF's or have a laptop on site to transfer to. I am not worried about battery power. The mypowers look like they can handle anything.

Sorry if the wrong place to ask here, I just cannot find any info. And you are all so knowledgeable.  But I don't see why it can't be reversed. and for cheap. THe interfaces are so similar.

Thanks in advanced. 

If I am understanding here, you are looking at getting a PMD660, but want to swap out the CF card for with the 80gig drive from your JB3? I suppose it could be done, but Sunjan pretty much summed it up.

If there is a Team PMD660 thread, you might wanna cross post this there too.

Offline slightlys

  • Trade Count: (4)
  • Taperssection Member
  • ***
  • Posts: 904
  • Gender: Male
Re: iRiver H120 CF Mod Attempt - Success!
« Reply #248 on: September 01, 2009, 12:30:02 PM »
Worked like a charm I now have a freshly modded H116  ;D
Peluso CEMC6>Bumblebee MiAGi-II silver clad cables>Bm2p+ mod UA-5 >  OCM R-44

Offline shaggy

  • Trade Count: (10)
  • Taperssection All-Star
  • ****
  • Posts: 1928
    • dwonk
Re: iRiver H120 CF Mod Attempt - Success!
« Reply #249 on: September 10, 2009, 07:36:30 PM »
Just wondering if anyone has used these 32GB A-Data speedys in H1X0s with any success....


Offline run_run_run

  • Trade Count: (7)
  • Needs to get out more...
  • *****
  • Posts: 5253
  • Gender: Male
Re: iRiver H120 CF Mod Attempt - Success!
« Reply #250 on: September 13, 2009, 06:28:44 PM »
http://www.dealextreme.com/details.dx/sku.18463

Its got less pins, just line it up where it will slide in?

Offline sunjan

  • Trade Count: (0)
  • Needs to get out more...
  • *****
  • Posts: 2006
  • Gender: Male
  • Taping since 1988, 28 years of fine recordings...
    • Just a handful of stuff I put on etree
Mics: A-51s LE, CK 930, Line Audo CM3, AT853Rx (hc,c,sc),  ECM 121, ECM 909A
Pres: Tinybox, CA-9100, UA5 wmod
Recorders: M10, H116 (CF mod), H340, NJB3
Gearbag: High Sierra Corkscrew
MD transfers: MZ-RH1. Tape transfers: Nak DR-1
Photo rig: Nikon D70, 18-70mm/3.5-4.5, SB-800

Offline run_run_run

  • Trade Count: (7)
  • Needs to get out more...
  • *****
  • Posts: 5253
  • Gender: Male
Re: iRiver H120 CF Mod Attempt - Success!
« Reply #252 on: September 16, 2009, 02:09:31 PM »
Can someone up a .rockbox folder of a successful mod? The HD was dead in the unit so I can't do it that way

Offline EarlyMorningRain

  • Trade Count: (7)
  • Needs to get out more...
  • *****
  • Posts: 2779
Re: iRiver H120 CF Mod Attempt - Success!
« Reply #253 on: September 16, 2009, 03:56:34 PM »
Can someone up a .rockbox folder of a successful mod? The HD was dead in the unit so I can't do it that way

from a H1xx or H3xx model?

Offline run_run_run

  • Trade Count: (7)
  • Needs to get out more...
  • *****
  • Posts: 5253
  • Gender: Male
Re: iRiver H120 CF Mod Attempt - Success!
« Reply #254 on: September 16, 2009, 05:06:13 PM »
Can someone up a .rockbox folder of a successful mod? The HD was dead in the unit so I can't do it that way

from a H1xx or H3xx model?
120

 

RSS | Mobile
Page created in 0.081 seconds with 39 queries.
© 2002-2024 Taperssection.com
Powered by SMF