read the thread carefully.
1.make sure youre using the right rom x50 is not an x50v is not an x51v you will brick it with the wrong one
2. copy the files to a freshly formatted fat32 sd card
3. when you try to get into image loader mode, hold the two buttons down and briefly tap the reset with your stylus while continuing to hold the two buttons for a few more seconds
4. give it time to find the nb0 files, it took several minutes on mine
5. test test test at home, dont be like steam powered and wait till you get in the field to find you have a problem. I will NOT take a recorder/build into the field without at least 20 hours of testing for dropped samples. This software and drivers was not designed for WM6, so it is on you to confirm that your setup works. I only run at full processor speed, but have tested at lower speed with mixed results. battery power is cheap, but lost bits are irreplaceable
so all i do is use bootloader and select/load this *.nb0 from a sd card..? do i need anything else..? i have wm5 installed...
thanks.