Taperssection.com
Gear / Technical Help => Ask The Tapers => Topic started by: Gordon on February 28, 2004, 05:54:30 PM
-
me and joel may run some stage lip 481 > UA 5 > JB3 tonight. didn't know if I should bring my eco charges.
-
no - 9v minimum
-
thats a good question, i might have to run down my batteries, and test their voltage when it finally turns off.. all i know when fully charged my batts push around 12 v's..
-
It runs on 12 volts. I use 2 6 volts to make 12. I set them up like that new
-
It's not 12V, it's 9. That's what it says on the back of the unit. A 9.6v battery is perfect.
-
i believe they can run off of 9-12 volts.
-
It's not 12V, it's 9. That's what it says on the back of the unit. A 9.6v battery is perfect.
The wallwart puts out 12v. So, at the very least it runs on 9-12v. Dunno the actual full voltage spec range, though.
-
I just went and looked at my UA-5 wall wart, and it's clearly marked 9V.
-
I know for fact it will run on 12 volts
-
It's been a few days but i put my meter on the UA-5 wall wart and it read 12v.