Become a Site Supporter and Never see Ads again!

Author Topic: Making a custom power adapter, advise needed  (Read 1718 times)

0 Members and 1 Guest are viewing this topic.

Offline mmadd29

  • (5)
  • Taperssection Member
  • ***
  • Posts: 581
  • Gender: Male
  • I've stopped drinking, but only while I'm asleep
Making a custom power adapter, advise needed
« on: March 18, 2011, 08:30:54 AM »
I have a power adapter that I found that is from an old computer.  It puts out 12V @ 15A.  I was thinking of cutting off the end and use it to power my four battery chargers in my rack. That way I would only use on recepticle in my power unit. 

 My chargers can run with voltage between 9 and 18 V.  I was going to just create four plugs on the end, in parallel to power the chargers.  15A is more than enough current to power the chargers, as the draw would be around 5A or so.  My power unit in my rack is rated at 20A output, so I see no issue there.

Although I have an engineering degree, it has been 20+ years since I used it so I just checking if I'm missing anything here in my assessment.

If anyone see's something I'm overlooking please let me know.

Thanks in advance.....
Superlux CM-H8K > UA5 > iriver h120 > Wave Labs > EAC


RSS | Mobile
Page created in 0.027 seconds with 25 queries.
© 2002-2021
Powered by SMF