Become a Site Supporter and Never see Ads again!

Author Topic: PCM-M1 vs. UA-5 front end  (Read 2497 times)

0 Members and 1 Guest are viewing this topic.

BobW

  • Guest
  • Trade Count: (0)
PCM-M1 vs. UA-5 front end
« on: January 21, 2004, 07:10:15 PM »
Is it worth putting the Edirol UA-5 in front of a M1 ?

I remember Sony's blurb that stated that the M1 was "nearly as good as an SBM-1"

Taping rock/bluegrass/folk/blues.
Currently using MC-012s, with TLs in my sights for stealthing.  :crazy:

Usually CD is the output, some archiving.

-Bob

Offline nic

  • Big In Japan
  • Trade Count: (1)
  • Needs to get out more...
  • *****
  • Posts: 4700
  • Gender: Male
    • half dead batteries
Re:PCM-M1 vs. UA-5 front end
« Reply #1 on: January 21, 2004, 07:42:12 PM »
I would say the UA-5 has a better pre and ADC than the M1


the water's clean and innocent

jpschust

  • Guest
  • Trade Count: (0)
Re:PCM-M1 vs. UA-5 front end
« Reply #2 on: January 21, 2004, 09:30:57 PM »
i really think the ua-5 out in front is a worthy investment.

Offline Craig T

  • Trade Count: (10)
  • Needs to get out more...
  • *****
  • Posts: 4312
    • LMA
Re:PCM-M1 vs. UA-5 front end
« Reply #3 on: January 22, 2004, 09:35:29 AM »
UA5 definitely has better mic preamps, and I would say it is a better A/D at 16bit.  I think the favorable comparisons between the M1 & stock SBM1 were basically the A/D, taking a line level signal.
Schoeps cmc6/4v / Beyer mc950 / Line Audio CM3, OM1 / ADK A51 / Church Audio CA-14
Naiant Tinybox v2.2 / NBox(P) / Church Audio ST9200 / CA-UGLY
Sony PCM-M10 / Zoom F3 / Zoom F6

Offline Scuba Jeremy

  • Trade Count: (0)
  • Taperssection Member
  • ***
  • Posts: 735
  • Gender: Male
  • "Ugh, is that digi noise?"
Re:PCM-M1 vs. UA-5 front end
« Reply #4 on: January 27, 2004, 05:08:22 AM »
Running the same rig, MC012s and M1, the UA5 is amazing. Well worth the investment.

Offline Sean Gallemore

  • Trade Count: (2)
  • Needs to get out more...
  • *****
  • Posts: 8316
Re:PCM-M1 vs. UA-5 front end
« Reply #5 on: January 27, 2004, 07:12:45 PM »
you will want a pre of some sort so you don't have to use the mic input on the m1.  I don't know how the adc compares, though.

 

RSS | Mobile
Page created in 0.052 seconds with 30 queries.
© 2002-2024 Taperssection.com
Powered by SMF