Placing this here too as well as the Open Forum in hopes that the right person will see this:
OK, first swing last night to run 24/96 using my new f410.
I ran skm140's>V3 24/96 on s/pdif> f410>Wavelab/Vaio and ran into a few problems.
The first problem was that I got to the venue plugged everything in and for some reason the f410 drivers were not running right. Wavelab DID NOT have the 410 in the pull down menu to choose for a recording card and after a couple of reboots I quickly came to realize that I needed to try to uninstall the drivers and reinstall them on the spot. I didnt have any problems like this in a test run at home and am a little confused why this might happen now. Hopefully it won't reoccur.
So, I got the drivers re-installed and a signal to run and it looked like everything was kool locking into my external signal at that bit depth and sample rate. (with a DAT running on the analog outs as back up....thank goodness!)
Well, I get home and both sets are full of crackly noise. Not intermittent, but continuous crackling.
I will run some more tests here at home and try to begin setting some presets so that I can just go and click a few buttons to expedite set-up, but does anyone know why this might have happened?
I also have a couple other questions about options with the f410, like ASIO monitoring, so if any of you that have successfully run a f410 for a bit could PM me privately that'd be great.
Here's to trial and error, but I'd rather have it be trial and success...Kk