Gear / Technical Help > Remote Power

Apogee AD1K Power Cable And Battery

(1/2) > >>

gormenghast:
I purchased the Apogee AD1K in the yard sale the other day.  I thought I had a cable for it but haven't located it yet.  What would it take to to make one with a SPDIF cable also?  And what is available these days battery-wise I could use with this thing?

Thanks.

jerryfreak:
the power on the 15-pin input is a bit of a challenge. perhaps look for a 15-pin dsub to cannibalize and hope that the power pins you need are used. most of these are molded and theyre not really setup for DIY solder jobs. you need pins 1 and 6 for spdif and 15-16 for power

also re: spdif i have an aes>coax laying around which is simple and robust.

ero3030:
Good old SLA.  4 pin XLR and your coax digi coming out of the 15 pin.  Should be extras round here.  Everyone owned 2 if u ran a ad1k

gormenghast:
Any suggestions as to what battery manufacturer to buy?  And the AC charger as well?

jerryfreak:
according to the manual, the low battery starts flashing at 11.5V, but the unit will operate down to 10.5

any LI-ion shouldnt be run lower than 10.8V so youre good to go if you dont use the apogee itself for battery indication. as power hungry as the AD1K is, id go with a larger battery

https://www.talentcell.com/lithium-ion-battery/12v/yb12011000-usb.html

Navigation

[0] Message Index

[#] Next page