Become a Site Supporter and Never see Ads again!
« previous next »
Pages: [1]   Go Down

Author Topic: Can anyone make Microdot extension cables?  (Read 2084 times)

0 Members and 1 Guest are viewing this topic.

Offline dmaster

  • Trade Count: (0)
  • Taperssection Member
  • ***
  • Posts: 335
  • Gender: Male
  • dance spaceghost dance!
    • ToriTraders
Can anyone make Microdot extension cables?
« on: July 14, 2006, 11:46:04 AM »
I'm planning on getting a longer boom (I'm thinking 6ft or so compared to my current 3ft) and I'm pretty sure the normal cables for my DPA 4061's are going to be too short.

I'm not too thrilled about paying $45/cable to get the DPA-made extensions, but is this the only way to go? 
Logged

Offline dmaster

  • Trade Count: (0)
  • Taperssection Member
  • ***
  • Posts: 335
  • Gender: Male
  • dance spaceghost dance!
    • ToriTraders
Re: Can anyone make Microdot extension cables?
« Reply #1 on: July 14, 2006, 02:27:57 PM »
actually that sounds like a pretty good idea, and a lot cheaper than $90 for a couple of cables.   I can make a 10 foot cable from the MMA to the MT a loooooot easier.   

Thanks!
Logged
Pages: [1]   Go Up
« previous next »
 

RSS | Mobile
Page created in 0.054 seconds with 26 queries.
© 2002-2024 Taperssection.com
Powered by SMF