Become a Site Supporter and Never see Ads again!
« previous next »
Pages: [1]   Go Down

Author Topic: H120 battery replacement question  (Read 1512 times)

0 Members and 1 Guest are viewing this topic.

Offline stantheman1976

  • Trade Count: (2)
  • Taperssection All-Star
  • ****
  • Posts: 1093
H120 battery replacement question
« on: May 12, 2008, 08:06:10 PM »
I ordered replacement Cameron Sino 2200mAh batteries for my H12 and 320.  The replacement is just a hair thicker than the original H120 battery so I left out the black rubber piece that goes around the hard drive.  Is that going to harm anything or should I try to squeeze it in?
Logged

Offline mrruin

  • Trade Count: (0)
  • Taperssection Regular
  • **
  • Posts: 117
  • Gender: Male
  • Team Europe
Re: H120 battery replacement question
« Reply #1 on: May 13, 2008, 03:01:44 AM »
I just squeezed it in when I replaced it this weekend. So far so good, it does sit a little tight though.
Logged
AT 943/h or U853/c > 3 wire "crown-royal" BB > ST 9100 preamp v2.0 > R-09
my shows: http://db.etree.org/mrruin *updated April 2nd 2007*
-------------
Team Europe

Offline petur

  • Trade Count: (0)
  • Taperssection Member
  • ***
  • Posts: 544
  • Gender: Male
  • wtb: time
Re: H120 battery replacement question
« Reply #2 on: May 13, 2008, 03:56:58 AM »
it fitted quite well in my h380.... leave the rubber in to protect the HDD...
Logged

Offline stantheman1976

  • Trade Count: (2)
  • Taperssection All-Star
  • ****
  • Posts: 1093
Re: H120 battery replacement question
« Reply #3 on: May 13, 2008, 09:05:32 AM »
Thanks.  I'll put it back in tonight then.  I was just worried that the extra pressure against the hard drive might be harmful.
Logged
Pages: [1]   Go Up
« previous next »
 

RSS | Mobile
Page created in 0.046 seconds with 29 queries.
© 2002-2024 Taperssection.com
Powered by SMF