Topic: violet flamingo

[eric.B]

violet flamingo stereo mic..    nice gif!

sory if previoulsy posted.. 

[ArchivalAudio]

sweet gif is right!

looks like a cool mic
any one test drive one of these suckas!?

I look on their site for more info
sweet!

[ArchivalAudio]

it is actually the stereo flamingo
specs
here
violet flamingo
http://www.violet-design.ee/index.php?option=com_content&task=view&id=89&Itemid=130


SPECIFICATIONS:

Transducer type    

electrostatic

Operating principle
   

pressure gradient

Diaphragm's active diameter
   

26 mm

Frequency range
   

20 Hz to 20 kHz

Polar pattern
   

unidirectional - cardioid

Output impedance
   

50 ohms

Rated load impedance
   

1000 ohms

Suggested load impedance
   

>500 ohms

Sensitivity at 1000 Hz into 1000 ohms load
   

21,5 mV/Pa

S/N Ratio CCIR 468-3 weighted
   

76.5 dB

S/N Ratio DIN/IEC 651 A-weighted
   

87.5 dB-A

Equivalent noise level DIN/IEC A-weighted
   

6,5 dB-A

Maximum SPL for 0.5% THD at 1000 ohm load
   

133,5 dB

Dynamic range of the internal preamplifier
   

127 dB

Phantom powering voltage on pins #2 & #3 of XLR
   

+48 V (+/-4 V)

Current consumption
   

<2 mA

Output connector
   

3-pin XLR male, gold plated contacts

Signal polarity
   

Positive toward pressure on a diaphragm produces positive polarity voltage on XLR pin #2 relatively to pin #3

Dimensions
   

160 mm x 220 mm x 140 mm

[muj]

what i never understood was what kind of stereo image is it suppose to refer to? ORTF?