0 Members and 1 Guest are viewing this topic.
J.D. is the main contact on this guys. I don't think we are close yet to getting these done, but it is being discussed.
Quote from: Myco on June 18, 2010, 01:05:35 PMJ.D. is the main contact on this guys. I don't think we are close yet to getting these done, but it is being discussed.Good, thanks for the update. I was wondering whether to get the yellow or white gold bookshelves for my gold house. I will hold off on the purchase until I can get a look at the shade of my gold MG NBox.
just a FYI for those looking to build one of these boxes.I used to own a JK Labs ECMS-23 for the MGs and I remember a conversation Jon and I had with regards to the cables/caps.at some point in production of the caps, MG changed the length of the center pin on the caps that plugs into the bodies. I do not remember what serial # range the change occurred at but you need to be careful if you have m20, m21, etc to make sure the pin is the same length (or the active cable has play in the connection to accommodate slightly different length pins).what Jon told me was pretty much of your caps are relatively close to each other serial # wise you should be fine interchanging the caps on the active cables but if there was a wide difference in serial #s to closely compare the caps to see if 1 pin stuck out further than the other.if I remember correctly the difference in length was maybe 1mm or so but I can not vouch exactly for that #...
Quote from: nic on April 12, 2010, 04:38:41 PMEvery now and then I get the hankering to pick up a set of MGs. Every now and then....
Quote from: page on June 19, 2010, 12:15:44 PMQuote from: nic on April 12, 2010, 04:38:41 PMEvery now and then I get the hankering to pick up a set of MGs. Every now and then....^I can't imagine you having any regrets in fulfilling that hankering.
Don't think this is going to happen. I spoke with Jamie and he said that it would take more effort to make these than their is interest in having them made. We only had a few people who were definite in wanting these and to have the electronics set up and have the boxes machined it would have been too cost prohibitory.