Become a Site Supporter and Never see Ads again!

Author Topic: Taping with Zoom H4 from Soundboard?  (Read 1536 times)

0 Members and 1 Guest are viewing this topic.

Offline DeltaBluesMan

  • Trade Count: (0)
  • Taperssection Newbie
  • *
  • Posts: 22
Taping with Zoom H4 from Soundboard?
« on: November 26, 2007, 01:28:42 AM »
How do I hook up my Zoom H4 to a soundboard to record a show? From where on the recorder to where on the soundboard? Also, the band will be playing four 45 min sets with 15 min breaks in between Should I shut the recorder off during the breaks?  When answering keep in mind I know very little about recording. Thanks!

Offline goodcooker

  • Trade Count: (43)
  • Needs to get out more...
  • *****
  • Posts: 4684
  • Gender: Male
  • goes to 11
Re: Taping with Zoom H4 from Soundboard?
« Reply #1 on: November 28, 2007, 05:44:28 PM »
since the Zoom thing has combo input jacks you could use several connections.
The engineer may offer one of many different outputs usually XLRmale, 1/4" or RCA

At a minimum I would have a pair of XLRs (mic cables) and a pair of 1/4" to 1/4". With a few adapters for RCA you should be covered in most situations.

Lots of pictures and info here http://taperssection.com/index.php/topic,14253.0.html

Last time I got a board patch it was mono, which was fine.
Line Audio CM3/OM1 || MBHO KA500 hyper>PFA|| ADK A51 type IV || AKG C522XY
Oade Warm Mod and Presence+ Mod UA5s || Aerco MP2(needs help) || Neve Portico 5012 || Apogee MMP
SD Mixpre6 || Oade Concert Mod DR100mkii

pocket sized - CA11 cards > SP SB10 > Sony PCM A10

http://www.archive.org/bookmarks/goodcooker

"Are you the Zman?" - fan at Panic 10-08-10 Kansas City
"I don't know who left this perfectly good inflatable wook doll here, but if I'm blowing her up, I'm keeping her." -  hoppedup

 

RSS | Mobile
Page created in 0.069 seconds with 28 queries.
© 2002-2024 Taperssection.com
Powered by SMF