Become a Site Supporter and Never see Ads again!

Author Topic: CA STC-11 > CA-9100 - non symmetrical recording  (Read 2718 times)

0 Members and 1 Guest are viewing this topic.

Offline nigelsh

  • Trade Count: (0)
  • Taperssection Newbie
  • *
  • Posts: 11
CA STC-11 > CA-9100 - non symmetrical recording
« on: May 10, 2009, 11:03:33 PM »
Hi I'm hoping that someone can suggest a possible reason why a recording would go 'non-symmetrical' part way through. If you look at the attached picture you will see that my recording is fairly evenly spread above and below zero until approximately 53 minutes in - at that point the sound below the zero midpoint is significantly less than that above zero.

I've noticed this phenomena in most of my recent recordings but have no idea what might be causing it - hence my hope that someone here may be able to suggest what might be wrong.

Thanks
Nigel

Offline heyitsmejess

  • Trade Count: (2)
  • Taperssection All-Star
  • ****
  • Posts: 1208
  • Gender: Male
Re: CA STC-11 > CA-9100 - non symmetrical recording
« Reply #1 on: May 11, 2009, 04:28:19 AM »
the battery in the preamp is dying.

are you using rechargeables? 
cause we zig and zag between good and bad
stumble and fall on right and wrong


http://www.rumpkemountainboys.org/

Offline nigelsh

  • Trade Count: (0)
  • Taperssection Newbie
  • *
  • Posts: 11
Re: CA STC-11 > CA-9100 - non symmetrical recording
« Reply #2 on: May 11, 2009, 09:11:25 AM »
yes, I'm using a rechargeable 9v battery. I'll try my next show with a new battery - thanks for the suggestion

Offline Belexes

  • Trade Count: (10)
  • Needs to get out more...
  • *****
  • Posts: 5223
  • Gender: Male
Re: CA STC-11 > CA-9100 - non symmetrical recording
« Reply #3 on: May 11, 2009, 09:19:19 AM »
Chris Church doesn't recommend those rechargable 9 volts.  You can get a lot of hours out of one new, non-rechargable.
Busman Audio BSC1-K1/K2/K3/K4 > HiHo Silver XLR's > Deck TBD

CA-14 (c,o)/MM-HLSC-1 (4.7k mod)/AT853(4.7k mod)(c,o,h,sc)/CAFS (o)/CA-1 (o) > CA-9100 (V. 4.1)/CA-9200/CA-UBB > Sony PCM-D50/Sony PCM-M10

Offline nigelsh

  • Trade Count: (0)
  • Taperssection Newbie
  • *
  • Posts: 11
Re: CA STC-11 > CA-9100 - non symmetrical recording
« Reply #4 on: May 11, 2009, 10:02:44 AM »
I'm glad I mentioned that I was using a rechargeable! I'll try a regular 9v for my next show on Wednesday. Thanks

Offline Chaosu

  • Trade Count: (0)
  • Taperssection Regular
  • **
  • Posts: 72
Re: CA STC-11 > CA-9100 - non symmetrical recording
« Reply #5 on: May 15, 2009, 03:16:12 PM »
Chris Church doesn't recommend those rechargable 9 volts.  You can get a lot of hours out of one new, non-rechargable.

It's more like he doesn't recommend common 8.4V accu, You just have to look for 9.6V one.

Offline sst4270

  • Trade Count: (0)
  • Taperssection Newbie
  • *
  • Posts: 37
  • Gender: Male

Offline Church-Audio

  • Trade Count: (44)
  • Needs to get out more...
  • *****
  • Posts: 7571
  • Gender: Male
Re: CA STC-11 > CA-9100 - non symmetrical recording
« Reply #7 on: May 15, 2009, 05:15:06 PM »
Such as this?

http://www.amazon.com/Maha-PowerEx-MH-96V230-Battery-rechargeable/dp/B0002LAKOS



Yes this one is very good. I recommend it to all of my customers it saves money in the long run and its better then throwing batteries in a landfill.

Chris
for warranty returns email me at
EMAIL Sales@church-audio.com

Offline sst4270

  • Trade Count: (0)
  • Taperssection Newbie
  • *
  • Posts: 37
  • Gender: Male
Re: CA STC-11 > CA-9100 - non symmetrical recording
« Reply #8 on: May 15, 2009, 05:42:09 PM »
Just found this...

http://www.batteryjunction.com/tpeh-t9-6v260.html

Anyone have any experience with them, yet?

Offline nigelsh

  • Trade Count: (0)
  • Taperssection Newbie
  • *
  • Posts: 11
Re: CA STC-11 > CA-9100 - non symmetrical recording
« Reply #9 on: May 15, 2009, 05:45:05 PM »
Thanks to everyone who has responded. A regular 9v battery fixed my problem - but now I'll probably pursue one of these 9.6v rechargeables

Nigel

Offline heyitsmejess

  • Trade Count: (2)
  • Taperssection All-Star
  • ****
  • Posts: 1208
  • Gender: Male
Re: CA STC-11 > CA-9100 - non symmetrical recording
« Reply #10 on: May 15, 2009, 07:30:04 PM »
i run my 9100 open alot.  when i do, i rigged up a connector so i can use a 9.6v RC battery.  ive let it run for 18 hrs straight at a festival and STILL had plenty left to record for a week straight.
cause we zig and zag between good and bad
stumble and fall on right and wrong


http://www.rumpkemountainboys.org/

Offline Jeremy Lykins

  • Trade Count: (3)
  • Taperssection Member
  • ***
  • Posts: 931
Re: CA STC-11 > CA-9100 - non symmetrical recording
« Reply #11 on: May 15, 2009, 07:46:07 PM »
i rigged up a connector so i can use a 9.6v RC battery.

That's pretty awesome.  You should make a DIY thread about that and put a link to it into the Team Church thread.  I'm sure that a lot of people would be interested in learning how to do that, even if they don't end up doing it. 

Offline heyitsmejess

  • Trade Count: (2)
  • Taperssection All-Star
  • ****
  • Posts: 1208
  • Gender: Male
Re: CA STC-11 > CA-9100 - non symmetrical recording
« Reply #12 on: May 15, 2009, 09:31:52 PM »
i would have to take some pics, but it was easy!  let me get the parts again, and ill do a full tutorial
cause we zig and zag between good and bad
stumble and fall on right and wrong


http://www.rumpkemountainboys.org/

 

RSS | Mobile
Page created in 0.076 seconds with 38 queries.
© 2002-2024 Taperssection.com
Powered by SMF