Taperssection.com

Gear / Technical Help => Ask The Tapers => Topic started by: Gordon on February 21, 2004, 06:50:30 PM

Title: eco charge 6V using phantom power...
Post by: Gordon on February 21, 2004, 06:50:30 PM
with a p1.  how long should I get?  I get over 3 without phantom power on.
Title: Re:eco charge 6V using phantom power...
Post by: airbladder on February 21, 2004, 07:53:18 PM
with my bp-50 I get about 6 hours if the incomming signal is digital.  If you are using the P1's A/D it will be less than that.  
Ed
Title: Re:eco charge 6V using phantom power...
Post by: F.O.Bean on February 21, 2004, 08:22:29 PM
Quote from: airbladder on February 21, 2004, 07:53:18 PM
with my bp-50 I get about 6 hours if the incomming signal is digital.  If you are using the P1's A/D it will be less than that.  
Ed

when i run digi in to the p-1, w/ my bp-50's i get 9 hrs easily, test it, i bet ya get the same, but w/phantom on and all that jazz, i havent a clue
Title: Re:eco charge 6V using phantom power...
Post by: BCostigan on February 21, 2004, 08:35:25 PM
I see you're running 480s so:


The best draw I could find for the dap1 = 1000mAh

draw for the 480s = 4mAh/pair


6 volts x 1 amp = 6watts

48 volts (phantom) x .004amp = .192 watts

6.192 watts / 6 volts = 1.032 amps

This is probably closer to 1.5 amps considering conversion efficiency.


The short version........you need 1.5 Amps per hour via 6 volts to run the p1/480 combo.
Title: Re:eco charge 6V using phantom power...
Post by: Gordon on February 22, 2004, 07:07:46 AM
got a board patch......
Title: Re:eco charge 6V using phantom power...
Post by: F.O.Bean on February 22, 2004, 10:28:28 AM
boooooooooooooooooooooooooooooooooooo :)
Title: Re:eco charge 6V using phantom power...
Post by: Gordon on February 22, 2004, 03:18:45 PM
an aud at the load ass bar would have sucked.  plus the boards from stella come out good as hell.
Title: Re:eco charge 6V using phantom power...
Post by: Gordon on February 22, 2004, 03:26:03 PM
Hot Tuna tonight!