Become a Site Supporter and Never see Ads again!
« previous next »
Pages: [1]   Go Down

Author Topic: Iriver clip indicator  (Read 1483 times)

0 Members and 1 Guest are viewing this topic.

Offline dcbullet

  • Trade Count: (0)
  • Taperssection Regular
  • **
  • Posts: 119
  • Gender: Male
  • SF, CA
Iriver clip indicator
« on: October 18, 2006, 01:29:18 AM »
I recorded my first show with the Iriver H120.  The clip indicator went off a few times (the face lit up) so I dutifully turned down the levels.  But when I went back to listen to the show, I didn't hear anything "bad" at all.  Does the clip "detector" work very well?

P.S.  I'm a beginner so excuse me if I'm retarded.
Logged

Offline Javier Cinakowski

  • !! Downhill From Here !!
  • Trade Count: (11)
  • Needs to get out more...
  • *****
  • Posts: 4325
  • Gender: Male
Re: Iriver clip indicator
« Reply #1 on: October 18, 2006, 08:39:16 AM »
slight clipping is often not audible.  The iRiver clip light and my SBM-1 clip light come on at the same time, so I think the iRiver levels work just fine...
Logged
Neumann KM185mp OR DPA ST2015-> Grace Design Lunatec V2-> Tascam DR-100mkIII

Offline dcbullet

  • Trade Count: (0)
  • Taperssection Regular
  • **
  • Posts: 119
  • Gender: Male
  • SF, CA
Re: Iriver clip indicator
« Reply #2 on: October 19, 2006, 12:02:27 PM »
Thank you.
Logged
Pages: [1]   Go Up
« previous next »
 

RSS | Mobile
Page created in 0.043 seconds with 28 queries.
© 2002-2024 Taperssection.com
Powered by SMF