Taperssection.com
Gear / Technical Help => Battery Boxes, Preamps, Mixers, ADCs, and Processors => Topic started by: dan434 on February 20, 2004, 12:21:28 PM
-
I have been having some issues with my 12-pin of late for my ad1k. The unit powers on just fine & I can get a signal via aes/ebu cable but I cannot get one from the coax/rca coming out of the 12-pin. Could this short out and need to be re-wired or is my cable just shot all together?? Any input would be great, thanks!
-
i have an extra one that i dont use anymore that went with my ad500e if you want that for a couple of bucks
-
If you go to the Apogee site, they have a pin-out drawing for that connector.
If you have a multi-tester it would be easy to figure out if the problem is in the cabling by checking continuity.
-
I can sell you one of mine if you want it, since no one will buy my ad500...
-
What calico said you can always re wire your 15pin the important part is that you have the actuall15 pin in tact.
-
you can get the 15-pin DSUB connectors at the shack for about 3 bucks FWIW
-
Hey, I can make these really easily if anyone needs one.