Topic: Determining current draw

[Chuck]

I know there is a simple way to find how much current a device draws using a Volt/Ohm meter.
Does anyone know how to do this?

[leegeddy]

I know there is a simple way to find how much current a device draws using a Volt/Ohm meter.
Does anyone know how to do this?

you really need a multimeter for ease of measuring. set your multimeter in series on the + side between the load (deck, pre, etc.) and the power source.

marc

[Chuck]

...and use the appropriate resistance scale?

[leegeddy]

...and use the appropriate resistance scale?

a multimeter can read current flow directly. no math is needed.

marc

[dklein]

My old analog multimeter couldn't handle anything that drew more than 1 amp so I picked up one of these at the electronics store for ~$10.  You just place it 'in the circuit' so the current flows thru the meter.  Analog meters are kinda nice when things are fluctuating.

[leegeddy]

My old analog multimeter couldn't handle anything that drew more than 1 amp so I picked up one of these at the electronics store for ~$10.  You just place it 'in the circuit' so the current flows thru the meter.  Analog meters are kinda nice when things are fluctuating.

damn, that's old school 

..getting flashbacks of science classes.

marc

[Chuck]

I've only got analog multimeters.

[Chuck]

My old analog multimeter couldn't handle anything that drew more than 1 amp so I picked up one of these at the electronics store for ~$10.  You just place it 'in the circuit' so the current flows thru the meter.  Analog meters are kinda nice when things are fluctuating.

Does a Mini-Me or a DAT deck draw more than 1 amp?

[Brian Skalinder]

Does a Mini-Me or a DAT deck draw more than 1 amp?

Ahem.    http://www.taperssection.com/yabbse/index.php?topic=2461.0

[Chuck]

Thanks Brian... you are always there with the right link...
That Mini-Me spec is hard to come by. I couldn't find a published number anywhere, including my manual and their web site.

[Brian Skalinder]

That Mini-Me spec is hard to come by.

Yeah it is.  Had to call Apogee directly to get that one and pry it out of 'em.  They didn't want to give out *any* number as it varies depending on the gear used, but I finally nailed 'em down to a rough number.

[Chuck]

Thank you for doing that research. +T

[dklein]

Yeah it is.  Had to call Apogee directly to get that one and pry it out of 'em.  They didn't want to give out *any* number as it varies depending on the gear used, but I finally nailed 'em down to a rough number.

There is some truth to that - different mics draw different amounts of phantom and the consumption goes way up when you crank the gain and push more output.  If you turn the gain way up the ammeter behaves more like a VU meter, bouncing around with the music.  But they should have at least provided a range.

[Brian Skalinder]

There is some truth to that - different mics draw different amounts of phantom and the consumption goes way up when you crank the gain and push more output.  If you turn the gain way up the ammeter behaves more like a VU meter, bouncing around with the music.  But they should have at least provided a range.

Definitely truth, but yeah - a published range would be nice like (ahem!) Grace Design offers. 

[leegeddy]

>>There is some truth to that - different mics draw different amounts of phantom and the consumption goes way up when you crank the gain and push more output.

absolutely. this is why designers usually post typical/average current draw (or power consumption) in their specs.

marc