Taperssection.com
Gear / Technical Help => Remote Power => Topic started by: steve4134 on July 29, 2021, 09:23:43 PM
-
Team,
Finally pulled the trigger and purchased the following.
https://www.amazon.com/gp/product/B01337QXMA/ref=ppx_yo_dt_b_asin_title_o01_s00?ie=UTF8&psc=1
Curious is any of the team uses the same battery and what type of run times.
Thank you
Steve
-
normal show you might lose a dot on the indicator
-
I’ve never used Talentcell.. but if you’re familiar with the “old” DVD batteries… those were 9v and typically 5400mAh.
So you ‘might’ be able to ballpark your new Talentcell (running @ 9v) based off of that.. which then the 9v Talentcell would be approximately twice the capacity of a single DVD battery.
Maybe. YMMV.
….or just listen to kindms who has real life experience with Talentcell! :D
-
You can get 6+ hours running a V3 and an R44 off of the same battery.
-
Thank you everybody.
Steve
-
I use one too, my setup i run ad2k+ (12 v) Grace V-3 (9 v) and Tascam DR100 III (5 v)
all at the same time. 3 hours of run time it goes down one light, so 12 hours running all 3
-
These things truly are excellent portable power. We can run a V2 off one and it only goes down one light after a 2-3 hour show!
We figure we could power that V2 over 24 hours on one charge. >:D
-
I just received my cable from Grace design. I am going to set it up before going to work one day and see how it does for 10 hours. Grace built the cable for the 9volt connection.
Steve
https://www.amazon.com/dp/B01337QXMA?ref=nb_sb_ss_w_as-ypp-rep_ypp_rep_k1_1_6&crid=3MQK6N6AN5SUW&sprefix=talent
-
where Can I get that cable steve? part number? is it an original grace dongel end that plugs in the unit back > a 9v talent cell?
I have a 6v v3
-
where Can I get that cable steve? part number? is it an original grace dongel end that plugs in the unit back > a 9v talent cell?
I have a 6v v3
I can build a v3 > talent cell cable for $35 shipped, hit me up
-
thanks Ted! :coolguy:
PM sent
-
it'll last a while. but the v3 will get hot as hell running off a 12v battery
-
The Talentcells we use have 12v and 9v outputs. We've been using the 9v to the V2's and they run cooler than using the 12v.
ALso, the 11,000mAH one would charge a v2 almost 24 hours I would bet. We've run that combo for 6 hours with a one bar drop.
-
11 Ah battery V3 pulls 1 A and has a linear regulator as it's first stage in the power circuit so it doesn't matter what voltage you run it at - better to run as close to 6v as possible
So V3 should run about 11 hours at full charge
-
Also-
About this item
12 volt (voltage range is 12.6V~9.0V)/6A(Max.) 8300mAh size is DC5521, 9V 1A/11Ah size is DC5525, 5V USB 2A/20Ah. Three port DC output multi-function lithium ion battery pack.
^
My bold on the description of that TalentCell above. The mAh rating indicated for each output would seem to indicate the battery will last longer if powering the V3 from the 9V port anyway. The 9V port is rated at 1A, same as the rated draw of the V3 thus leaving no excess current capacity, but if its been working for others without a problem it should be okay.
Good to be aware that TalentCell offers a few different capacities in each "fame size" housing. I almost posted the wrong info as my TalentCells look identical but have a different capacity rating, with an 11Ah capacity from the 12V port. So somewhat easily confused.
About this item
12 volt (12.6V~9.0V)/6A(Max.) 11000mAh, 9V/1A 14500mAh, 5V/2A 26400mAh DC output Lithium ion battery.
I run the recorder (F8, DR680, or R44) from the 12 port, and have figured I'd run the V3 from the 9V port of the same battery simultaneously. I've tested that combination at home and it works, but have yet to run it at a show or determine how long it will actually run.