Hello Folks!
I've done a search and scanned thru many headers to posts and have not found how to properly do this.
Attenuator? 40 rating? placed between the MM-1 and DR-40?
Looks to me it will take an XLR to 1/4 into the DR-40, to keep out the DR-40's Preamp...with Line In set on the DR-40.
As above, DR-40's Mic Gain Setting should be set to what setting?
I will be running an AT-897 into the MM-1.
I'm not versed in electronics, so here goes the Title question. So I post the following specs for you.
Many thanks!
Brian Depew
MM-1 Key Specs
Gain: (Mic - Line): 0 dB to 66 dB input to output, switch selectable
Dynamic Range: (Mic to Line) 122 dB minimum at the +18 dB gain settingGain Accuracy: (Mic - Line) +0.6, -0.1 dB with reference to front panel gain markings (150 ohm source, 100 k load impedances)
Output Clipping Level: (Line) +22 dBu minimum with 100k ohm load+20 dBu minimum with 600 ohm load
Input Clipping Level: (Mic) +4 dBu minimum at the 0 or +18 dB gain setting
DR-40 INFO
EXT MIC/LINE IN
Connector XLR/TRS Combo Jack (1:GND,2:HOT,3:COLD)
Input Impedance 2.2kΩ(MIC)/10kΩ(LINE)
Nominal Input Level -19dBV(MIC) / +4dBu (LINE)
Maximum Input Level -3dBV (MIC) / +20dBu (LINE)
PHONES/LINE OUT
Line Connector 1/8(3.5mm) Stereo mini-phone jack, unbalanced
Output impendence 12Ω
Nominal output level -14dBV(10kΩ loaded)
Maximum output level +2dBV(10kΩ loaded)