Taperssection.com
Gear / Technical Help => Battery Boxes, Preamps, Mixers, ADCs, and Processors => Topic started by: corsair on September 05, 2005, 09:21:35 PM
-
Hi folks...
I was comparing two preamps... One said it had an output of 2V rms into a 10k load
while another had 3.5V rms into a 10k load.
What does this translate into? ? ? ???
Thanks!
-
root mean square voltage, its a way to measure voltage, here are some sites with info on it
http://www.bcae1.com/voltages.htm
http://www.kpsec.freeuk.com/acdc.htm
the load i am not sure about, when i have seen it talked about its usually in ohms