Taperssection.com
Gear / Technical Help => Battery Boxes, Preamps, Mixers, ADCs, and Processors => Topic started by: bgalizio on April 13, 2005, 07:18:29 AM
-
I scored a UA-5 off eBay for only $155 yesterday. I can do the digi-mod myself, but I had one question for the DIY guys out there: any preference/experience/recommendations about removing R8 instead of cutting the line? From what I've read, both are ok and get that part of the job done, but I haven't really seen anything about which method is preferred.
-
well if you completely remove r8, it'll be a lot harder to reattach that, then to just solder the line back together if you ever want to revert it back to normal use.
-
I just cut mine and didn't think that it was too difficult. But I've heard of some people on here having problems with it. Use a really sharp exacto knife.
-
i cut mine w/ an exacto w/ a brand new blade.
Used a piece of wire from some CAT5 preshaped like a Z
-
Thanks for the info. +T to the thread. I'll let you guys know if I have any problems, though it looks like a simple mod.
Got the WalMart special battery and Radio Shack cable today too. Will be a nice addition. Can't wait until I have the dough for some mics and do matrix recordings!
-
The circuit board was a little too small for my tastes, so I took it in to an electronics shop to have it professionally done. Didn't take much time, or cost much, and it works great! I ended up having him cut the line just like the instructions say.
-
I scored a UA-5 off eBay for only $155 yesterday. I can do the digi-mod myself, but I had one question for the DIY guys out there: any preference/experience/recommendations about removing R8 instead of cutting the line? From what I've read, both are ok and get that part of the job done, but I haven't really seen anything about which method is preferred.
Sorry for the total newbie question, but what's this mod for?
If I buy a stock UA-5, is there a reason it can't be used as is with a JB3?
-
Sorry for the total newbie question, but what's this mod for?
If I buy a stock UA-5, is there a reason it can't be used as is with a JB3?
Check out the UA5 FAQ in Archive | Pres, ADCs, & Processors.