I've made a few cables, and usually they are pretty clean. I've also seen some other cables and taken them apart to see how they were put together and sometimes there is a silicon looking hardened epoxy in there providing more insulation and support...
I've thought about filling my cable plugs up with something similar, but don't know what to look for or what I can use. I've looked at RatShat, but couldn't really find anything... Of course, I didn't look too hard as I was there buying something else...
But then I thought I might be able to use Elmer's Glue, but that is water based, so I thought it would be conductive...
Does anyone know anything about this stuff??? Should I be using something like this, or should I avoid it? If so, what can I use and where can I get it?
Thanks,
Terry Watts