Hey Now - Ran my new V3 with the Nak701's at SCI this weekend for the first time (Friday & Saturday). Some general observations made perhaps someone can comment on:
Setup: Nak701's (ORTF) > Luminous Audio PS > V3 > D8
Next to SBD, approx. 50ft from stage on front of TS line.
1. Had us setup right next to SBD in very close location to the stage - great sound for this venue (just at edge of overhang of the balcony). One thing I noticed was that I had to crank the V3 up to 55db setting (second highest) on the mic gain to get my levels correct. Now considering that my mod Nak701's have a -15bd attenuator barrel attached to the capules most likely have atten. the signal down as such that it forced the V3 to be cranked up higher??? Still a very clean signal but aside from changing out the -15db atten. barrel (not an option) what else can I do to boost my signals up higher so I don't have to crank the V3 so much?? In line transformers??? Any idea's?? Anyone else who run the mod 700's with the atten. have this issue with the V3 or MMe??
2. Second observation was that the first night sounded a little on the boomy side on the low end. Recognizing that the Nak700's have a strong low end I ran the second night on HPF #2 setting to take advantage of the lowend pass filter. The results of the second night were flat out amazing!! The first night was also very good, but I prefer the lowpass in that setting much better. Should this be the rule of thumb for running the V3 with these mics or was this partial to the venue (thus being a judgment call for each venue I run at). What is the rules of engangment for the HPF settings??? Experiences with others??
Otherwise I REALLY liked the V3>Nak701 combo!! With the lowpass it sounded very clean and crisp on the highend with amazing detail and speed!!
Looking for feedback and tips!!