Taperssection.com

Gear / Technical Help => Microphones & Setup => Topic started by: philfernandez on January 15, 2008, 09:55:01 PM

Title: mounts for church 11s
Post by: philfernandez on January 15, 2008, 09:55:01 PM

I recently purchased the 11s from Chris.  What do you folks recommend as the best mounts for them in non-stealth scenarios.  These mics came with the clips.  Will that make it difficult?  Thanks!

Title: Re: mounts for church 11s
Post by: NOLAfishwater on January 15, 2008, 11:26:50 PM

http://www.soundprofessionals.com/cgi-bin/gold/item/SP-GNA-3 (http://www.soundprofessionals.com/cgi-bin/gold/item/SP-GNA-3) I have a set and they work great!

Title: Re: mounts for church 11s
Post by: heyitsmejess on January 15, 2008, 11:30:26 PM

i just use the clips and mount them right on a mic clip.  then configure as needed.

Title: Re: mounts for church 11s
Post by: vanark on January 16, 2008, 07:48:08 AM

I use Tensimounts on a standard t-bar.  I don't have the clips on mine, but I think it should work without a problem.  The Tensimounts are very flexible.

(http://i23.photobucket.com/albums/b374/vanark/RoseHillDrive2007-11-07/mics2007-11-07_01a.jpg)

http://www.tensimount.com/

Title: Re: mounts for church 11s
Post by: Belexes on January 16, 2008, 07:54:34 AM

Quote from: NOLAfishwater on January 15, 2008, 11:26:50 PM

http://www.soundprofessionals.com/cgi-bin/gold/item/SP-GNA-3 (http://www.soundprofessionals.com/cgi-bin/gold/item/SP-GNA-3) I have a set and they work great!

Seconded. I don't have Church mics yet, but the MM's are a similar size and fit nice and snug into this.

Title: Re: mounts for church 11s
Post by: philfernandez on January 16, 2008, 08:58:15 AM

Thanks for the guidance!  I was thinking about the Tensimounts on a T bar, but I was not sure if this would allow for an XY set up.  My understanding is that the mic heads need to be nearly touching for this and I can't see how that would be possible due to the size of the mics (when using a standard sized T bar).  I do not believe any of this would matter when using the omni caps.  Thanks again!

Phil

Title: Re: mounts for church 11s
Post by: vanark on January 16, 2008, 09:06:39 AM

Quote from: philfernandez on January 16, 2008, 08:58:15 AM

Thanks for the guidance!  I was thinking about the Tensimounts on a T bar, but I was not sure if this would allow for an XY set up.  My understanding is that the mic heads need to be nearly touching for this and I can't see how that would be possible due to the size of the mics (when using a standard sized T bar).  I do not believe any of this would matter when using the omni caps.  Thanks again!

Phil

Correct, in an XY, they would be a couple inches apart (I've yet to run it this way).  But, it is perfect for DIN.