Gear / Technical Help > Playback Forum
Custom Build Acer 61 Turntable
raymonda:
Every part on this table is absolutely brand new. VPI sells motors, tonearms, bearings and platters, as does Origin Live. The platter and bearing goes for $1000.00 and the motor from OL goes for $850.00. The tonearm is around $700.00 with all its parts. The plinth was around $500.00 to build. The dustcover was about $225.00 and the extra bits were another $150.00. So in total this table cost around $3000.00 to build, sans cartridge.
raymonda:
A few more sexy shots.
Chilly Brioschi:
Looks like the table that P.M.Trudeau would own <wiggles eye brows>
kindms:
Thought of this thread
Chilly Brioschi:
^ I take it that you aren't Eastern European ... Annoying ballet was the bane of my childhood.
I was slapped often for my commentary, but who could avoid it?
Navigation
[0] Message Index
[*] Previous page
Go to full version