Taperssection.com
Gear / Technical Help => Battery Boxes, Preamps, Mixers, ADCs, and Processors => Topic started by: One Cylinder on December 15, 2011, 04:37:20 PM
-
I can't tell from the V3's owner manual -- which set of specs apply to a stock V3?
HPF SWITCH POSITION and CUTOFF FREQUENCY:
1 = 100Hz
2 = 50Hz
OR
1 = 125Hz
2 = 75Hz
Thanks...
-
they both do, it's controlled via switchable jumpers inside the unit
-
......should have been more clear - when the V3 leaves the production floor, to which specs are the jumpers set?
-
Only way to know for certain how your unit was configured on the production floor: open it up and check the jumpers. It's very easy to do, and as long as you don't mess around with anything inside, you can't hurt it.
-
When new, theyre at 50/100
-
.....Thanks Bean. That was a tough one! ;D