Become a Site Supporter and Never see Ads again!
« previous next »
Pages: [1]   Go Down

Author Topic: attenuator cable question  (Read 1473 times)

0 Members and 1 Guest are viewing this topic.

Offline jjazzfusion

  • Trade Count: (0)
  • Taperssection Newbie
  • *
  • Posts: 22
attenuator cable question
« on: April 17, 2010, 12:39:58 PM »
I'm using Coresound Binaurals w/switchable bass roll-off, with an Edirol R-09HR.

Do I need to use an attenuator cable with this setup? ???

Thanks for your help :)
Logged

Offline nickee

  • Trade Count: (1)
  • Taperssection Regular
  • **
  • Posts: 66
  • Gender: Male
Re: attenuator cable question
« Reply #1 on: April 24, 2010, 05:12:45 AM »
No.
Logged

Offline SmokinJoe

  • Trade Count: (63)
  • Needs to get out more...
  • *****
  • Posts: 4210
  • Gender: Male
  • "75 and sunny"... life is so much simpler.
    • uploads to archive.org
Re: attenuator cable question
« Reply #2 on: April 26, 2010, 04:27:44 PM »
Most of the time when I run CSBs > battbox > R09 I run "line in" with the gain at max and that puts the levels right where I want them... to the point where I know from experience I can "set it and forget it"  >:D  If it's really loud, turn the gain down a little.
Logged
Mics: Schoeps MK4 & CMC5's / Gefell M200's & M210's / ADK-TL / DPA4061's
Pres: V3 / ST9100
Decks: Oade Concert Mod R4Pro / R09 / R05
Photo: Nikon D700's, 2.8 Zooms, and Zeiss primes
Playback: Raspberry Pi > Modi2 Uber > Magni2 > HD650
Pages: [1]   Go Up
« previous next »
 

RSS | Mobile
Page created in 0.05 seconds with 27 queries.
© 2002-2024 Taperssection.com
Powered by SMF