I found the information out from my customer..
The tip is the red wire or + Bias input
The ring is the Yellow wire or Audio out.
The sleeve is of course ground.
For anyone that needs to know this..
Chris
Would this be the same for some AT 853's? I need to rewire some 853's for a 3-wire CA-9100 w/ 2 stereo 1/8 connectors. thanks!
Red is pin 3 Yellow is pin 2 and sheild is pin 1.
Chris
Thanks, Chris, but that's not exactly what I was asking--sorry if I wasn't clear. For some reason I have in the back of my mind that the SP mics are wired opposite of the AT mics and I was trying to verify the T/R/S protocol. I'm removing the phantom adapters on my AT 853's and am adding some stereo 1/8 connectors for a 3-wire 9100.
This would be a good question for SP not me since I am not familiar with how they wire things. I did find out that
the tip is the red wire or + Bias input
The ring is the Yellow wire or Audio out.
The sleeve is of course ground.
So if you were going to "cut the ends off" and wire to a 3 wire mini xlr you would do the following.
Pin 1 = Ground wire
Pin 2 = Yellow wire
Pin 3 = Red wire