Topic: Countryman E6 wire config. Help needed.

[iriewsp]

I have a countryman E6 mic that terminates into a trs mini 1/8 inch connector.  There seems to be only two wires in this cable.  A shield, and a white.  Im trying to figure out how to wire this.  There seems to be some sort of device soldered to the tip and the sleeve connecting the two.   Im not sure, but Im taking a guess that I solder the white to the ring and shield to the sleeve?  Can anyone help me with this?

[oleg]

where do you want  to stick it

[Church-Audio]

I have a countryman E6 mic that terminates into a trs mini 1/8 inch connector.  There seems to be only two wires in this cable.  A shield, and a white.  Im trying to figure out how to wire this.  There seems to be some sort of device soldered to the tip and the sleeve connecting the two.   Im not sure, but Im taking a guess that I solder the white to the ring and shield to the sleeve?  Can anyone help me with this?

What wireless pack are you running it into?

[iriewsp]

Im not positive the exact kind, but Its a shure wireless body pack.  I'll dig up the exact model number.

[Church-Audio]

Im not positive the exact kind, but Its a shure wireless body pack.  I'll dig up the exact model number.

A shure body pack that is 3.5 mm input? thats very strange I have never seen one before but I would assume it would be Ring for mic and tip for line and ground for ground the tip might have to be shorted to ground or a resistor to ground might be needed you should contact shure..

[iriewsp]

Sorry guys.

Its a sennheiser ew300.   It looks like there is a resister soldered between the tip and the sleeve.  Basically Im just trying to fix this.  It got broken and Im trying to fix it instead of paying for someone to fix it.

Thanks for you help guys.

Take Care
Mike

[oleg]

that probably a zenner diod
check on countryman site they have wierles wiring for almost every tx , look for g-2 9 100,300,500 0 they are same

[iriewsp]

Thanks guys. 

This is what I got, and just to make sure so I dont ruin the thing.

I solder the sleeve to the sleeve and the white cable to the tip, and then jumper the tip to the ring?
   

3.5 mm plug
   

Sleeve = S
Tip = W
Jumper ring to tip
5V Zener Diode
+ to tip
- to sleeve
   

Thanks for helping me. 
Mike