Taperssection.com
Gear / Technical Help => Battery Boxes, Preamps, Mixers, ADCs, and Processors => Topic started by: powermonkey on September 30, 2009, 08:19:57 AM
-
Hi all.
I'm looking to put together a decent rig based around a pair of Peluso CEMC6s and an R44, but I was wondering how I could go about using the Pelusos with my R09HR.
Would I be able to use an ART Phantom 2 to power the mics and go from that into the R09HR? Also, would I require an external pre to use the Pelusos and the R09HR? I have an FEL preamp, so would it be feasible to go mics > art phantom > fel bma1 > R09?
Cheers the help folks.
:)
-
it would work, you need a xrl > 1/8 from the art2 in the pre
depending on your levels you may or may not need the pre at all
-
^ That's kinda what I was thinking. You might be able to get enough gain out of your recorder and not have to keep the BMA-1 in the chain. You could always supply a little gain off the R09 and then add a little more in post if the recorder gets noisy at higher levels.
-
Thanks for starting this topic! I'm looking at getting a couple Studio projects c4s and the ART phantom 2 was mentioned as a great pairing but I still am wondering if I'll need my pre in the chain as well. Anyone have any experience with this?
-
I would put in my usual recommendation for a Naiant littlebox mic preamp. It will provide phantom power for the peluso's and it incorporates a very nice sounding mic preamp. All in a pretty small and low-priced package.
Search around a bit and you can find some littlebox preamp comps chuck and I have run.