Replaced caps for the bass section of the planar driver. The caps were too big to fit into the the Maggie's crossover box, so, I drilled a some holes into the box, placed rubber grommets into the holes, to avoid sharp edges, and mounted the caps on the top of the box by running cable through the holes. I then secured the caps to the box by, again drilling holes, adding rubber grommets and tethering them down with Zip ties. If I go the path or replacing the inductors I will need to using a larger box, which can cost extra cash. I would also replace the binding post, too. However, that would add and extra $200 to the project and I'm not ready to go there. Maybe over the next 12 months or so.
Anyway, here is a shot.