Taperssection.com
Gear / Technical Help => TS Knowledge Base / Archive => Remote Power => Topic started by: gdplusmore on August 28, 2009, 06:43:39 PM
-
Nakamichi MX-100_Power_Schematic
Link to purchase mini din connectors
http://www.hosfelt.com/en-us/dept_173.html
other parts for battery box can be obtained at radio shack
-
Is that schematic right? I believe the batteries hooked that way are 18 volts. not saying it won't work but I do not believe its 9 volts. postive to postive/negative to negative=9volts
-
This works for me...I had downloaded this from
http://www.nakmics.com/ a few years back. I get at least 4 hours per show
-
ziko, the batteries are connected in series, but notice that the "center point" between them is connected to the ground pin of the connector. This means that they will actually supply -9 Volts and +9 Volts respectively to the preamp, which is close enough for rock 'n' roll in this case.
-
Its right, I drew up that sketch ages ago and posted it someplace on the webs. I got it from some other Nak guru at the time. Worked for me and was very reliable. Funny to come see this dwg come full circle. I have been semi retired for about 6yrs now from the taping scene but have been considering getting back into it in 23'.