so you say you havent tested 96k yet?
what exact driver version are you using?
my av710 with kernel streaming and winamp requires manual sample rate switching, as 96k is different than all teh others.
heres my post from hydrogen audio awhile back (never got any replies unfortunately):
ok, heres my setup:
winamp 2.91
kernel streaming plugin 3.63
Chaintech AV710 w/ envy 24 ht-s chipset
I initially tried using (i beleive) 5.20 via drivers for the envy. This didnt work so hot, and i uninstalled and tried to install 4.73.
I know the de/re-install was not completely clean, as the envy utility shows a driver version of 5.12.xxx
I need to play back audio at various sample/bit depths spdif out to a DAC.
I have verified that the card is 100% bit accurate when playing back 24/96 wav or flac (i recorded the stream coming off of it, then compared it in a wave editor, it was bit-for bit identical).
the via audio panel is setup in 'high sample rate mode' at 96K.
the problem being, i cant figure out any way to play back 44.1 or 48k audio, even if i switch it from high sample rate into normal 2-channel mode, i get no sound out.
Is there a driver amonsgt the 5.2 or 4.73 that can work and handle 'auto sample rate' appropriately for both low and high sample rates? I dont want to have kmixer messing with my bits, and asio4all just doesnt really work for me.
I want to use this setup for an htpc, and it has to work all the time without changing control panel settings up.
alternatively, i would switch to foobar if the appropriate IR remote plugins were avaialble. I'm currently using winamp on my htpc with girder+irman to translate ir remotes into winamp commands