Taperssection.com
Gear / Technical Help => Cables => Topic started by: rowjimmytour on November 22, 2005, 01:32:19 PM
-
I plan on making a 6' RCA cable run for Sound board patch. Cable I am using L-4E6S BE Canare Star-Quad Microphone, and one end of the pair of cables well have SW3502RAAU Right Angle RCA Connector-Nickel/Gold and the other end F-10 Canare F10 RCA Plug. I just wanted to be clear if ya get the two blue (hot) wires inside and solder them to the pin and then you get the shield and solder to the outside of the connecters. Thanks in advance for your help!!!
Peace
-
I am not making mic cable Moke I am making RCA cable!!! Thanks though and +t for the advise specially when your doing mic cable because when I did it I installed right angle Male and Female XLR ends which amde it very difficult.
Peace
-
I would run the blue wires for the signal/tip and use the white wires (not the outer ground shield) for the ground/outside of the connector. Actually, for the best shielding against interference, I'd do blue to signal/tip, white to ground/connector, and then also tie the ground shield of the Canare cable only to the connector ground on the soundboard side (no connection of the Canare ground shield at your recorder/preamp side).
-
+t Todd R and mucho gracias hermano!!!!
Peace
-
Sorry Moke the first time ya explained in your post I didn't get it! Until
-
SDB patch kit!! Finished product.
-
Pretty :)
How much did that run you to make? About...
-
2 [NA2FPMF] Neutrik XLRF-RCAF Adapter @$10.96/ea = $21.92
2 [NA2MPMF] Neutrik XLRM-RCAF Adapter @$9.68/ea = $19.36
2 [SW3502RAAU] Right Angle RCA Connector-Nickel/Gold @$3.79/ea = $7.58
2 [F-10] Canare F10 RCA Plug @$2.70/ea = $5.40
6 [L-4E6S BE] Canare Star-Quad Microphone Cable Blue @$0.36/ea = $2.16
6 [L-4E6S GN] Canare Star-Quad Microphone Cable Green @$0.36/ea = $2.16
-
Just ordered some canary starquad cable
Yellow cables? ;D
-
SDB patch kit!! Finished product.
nice, how much did everything cost?
+t
-
Once again!!! ;D
2 [NA2FPMF] Neutrik XLRF-RCAF Adapter @$10.96/ea = $21.92
2 [NA2MPMF] Neutrik XLRM-RCAF Adapter @$9.68/ea = $19.36
2 [SW3502RAAU] Right Angle RCA Connector-Nickel/Gold @$3.79/ea = $7.58
2 [F-10] Canare F10 RCA Plug @$2.70/ea = $5.40
6 [L-4E6S BE] Canare Star-Quad Microphone Cable Blue @$0.36/ea = $2.16
6 [L-4E6S GN] Canare Star-Quad Microphone Cable Green @$0.36/ea = $2.16
Also (2) 1/4">1/8" adapter plugs I bought from rat shack for probally a buck and change.
Peace
-
did you ever post a price for the materials? :P ;) ;D
-
did you ever post a price for the materials? :P ;) ;D
i was wondering the same thing ;)
thanks for not killing me when i overlooked the prices
just thought of this though--are you going into the ua5 or how do you get the signal to a stereo 1/8 to go into the jb3?
-
SDB patch kit>UA5>NJB3
:)
-
Pretty sharp! I just want to chime in with some anal info...
First, you realize if your ever hooking up the XLR adapters to both side, you'd be better off with a fully balenced/grounded XLR to XLR. Thats probably obvious. Same goes for a connection involving 1/4" to XLR. Using TRS 1/4" to XLR fully balenced/grounded would be prefered. I repeat that this is over the top anal info, just thought it might be handy for some people.
Also, everyone knows it is pronounced canare [cun are ee], not like the bird, right? ;D
-
Did you order your cabling from Markertek? That seems to be the most affordable outlet around.
-
2 [NA2FPMF] Neutrik XLRF-RCAF Adapter @$10.96/ea = $21.92
2 [NA2MPMF] Neutrik XLRM-RCAF Adapter @$9.68/ea = $19.36
2 [SW3502RAAU] Right Angle RCA Connector-Nickel/Gold @$3.79/ea = $7.58
2 [F-10] Canare F10 RCA Plug @$2.70/ea = $5.40
6 [L-4E6S BE] Canare Star-Quad Microphone Cable Blue @$0.36/ea = $2.16
6 [L-4E6S GN] Canare Star-Quad Microphone Cable Green @$0.36/ea = $2.16
Yes, these prices are from Markertek.
Peace