Taperssection.com
Gear / Technical Help => Ask The Tapers => Topic started by: nic on December 29, 2003, 09:43:07 AM
-
for those familiar with the Electric Factory what config would you run from the taper section?
its been a couple of years since I personally ran mics there and I didnt make a note of what config I used...with 391's, I *think* I used ortf from the front center corner.
gonna be running TL's and I'm leaning towards running the cards nutter style
-
If the section is still near the stairs, I went with DIN with SR77s. ORTF got too much "room" for my liking.
-
i think im runnin DIN, luvean, look for me in lne, ill be there early, red OSU hat, you rollin tape for antigone rising, im just gonna check levels
-
anitgone rising??
maybe your thinking of a different show.
I'm talking about the Biscuits with New Deal opening on 1/3.
ugh, just finished rebuilding my 7pin cable...
have to test it tonight in case I have to order a new one for the show
-
whoops, thought you were talking about the moe show tomorrow
-
i always run din at the electric factory, and i use akg 391's
in the tapers section...which is simply marked off with tape to the left of the sbd...there is in the front right corner an "X" on the floor
i find this is the best spot in the factory to setup a stand. always good results from the magic "X" in the tapers section
not sure who put the "X" there, but it never fails for me
i'll be at moe. , ..and maybe the biscuits
-
im gonna beat you to the X at moe.
-
he, he....i don't think so, but i'll share a stand with ya!
-
last year when the biscuits played NYE at the E Factory, the sbd was off to the left near the stairs. the taperssection was directly to the right of that, a little inside of the right stack but nowhere near centered. running that far back in that room, i would def run hypers. kevin hughes ccm4v's picked up a lot more echo and room noise than nick's 483's which he ran DIN. hope that helps, i'll be at clifton park and nyc, wish i had some hypers for the hammerstein.
-
pretty sure the section has moved from the side to the center, which is alot better. i tried to tape randolph there a week back or so ( didn't happen though) and it looked like it was back to the old section, center. good luck.