Taperssection.com
Gear / Technical Help => Recording Gear => Topic started by: PianoManGrj on June 30, 2010, 02:28:01 PM
-
Hey folks, I just noticed that when I adjust my levels while recording there's a "click" every time I raise or lower my level. This just started recently... Anyone have this problem or know where I can get it fixed?? It's almost 2 years old and I found out it was refurbished after I bought it. No other problems (knock on wood!) Thanks for the help,
Gregg
-
You just didn't notice it before. All HR's are like this. If you need to change levels during a show and are not using a preamp for that, try to adjust them during applause if possible. Then you can cut out the noise without hearing any glitches.
-
yes Frank is correct, it's always been there; I didn't believe it but I listened to my recordings and noticed it as well. I usually do my adjusting during the very beginning of the act and during warm up so I'm less likely to use that audio. use the pre-amp to raise the gain and you won't have to deal with the clicks.
-
Really? Thanks, I usually only tape my band or stealth so I hardly ever get to adjust levels while recording. I discovered it this summer while taping Phish. It is kind of hard though to set levels when there's no opening band :) Oh well, I'll work around it.
Thanks again