Taperssection.com

Gear / Technical Help => Ask The Tapers => Topic started by: nangillala on October 19, 2010, 07:22:41 AM

Title: How to set the Levels with M10 and Church Mics?
Post by: nangillala on October 19, 2010, 07:22:41 AM

Hi there,
I've got a Sony PCM M10 and the Church CAFS Mics. Unfortunately I have no Battery-Box available at the moment.
Until now I only recorded my own singing/guitar playing, etc. and I had no problem with the Auto-Mode on the recording level.

Now I want to tape a show (Vocals, Guitar, Bass, Drums), that's kinda singer/songwriterish, but amplified and thus a bit louder (no Hard-Rock over the top volume show ;) )

Any recommendations on what to start with the levels? I guess the "auto" mode is not recommended for concert taping. So what would you suggest, what are your experiences?

Cheers,
Florian

Title: Re: How to set the Levels with M10 and Church Mics?
Post by: Belexes on October 19, 2010, 01:31:08 PM

I don't think the M10 can properly power the CAFS in regards to an amplified show. I'd get a battery box if at all possible.

In regards to levels, start low and at 24 bit and work your way up to -12dB to -6dB peak. Boost the levels in post as needed.

Title: Re: How to set the Levels with M10 and Church Mics?
Post by: nangillala on October 19, 2010, 05:15:30 PM

Hi Belexes,
thanks for the answer. I had a battery box but had problems with it, so I have to tape this show without one (or at least try to).  :-[