Print Page - adapting female threads on ld mics for akg km235

Title: adapting female threads on ld mics for akg km235
Post by: busknuckle on February 19, 2004, 08:26:31 PM

So I'm borrowing some Oktava 319 LD's (thanks again Jonny) to tape a show next Thursday. There is a minor problem though:

The threads on the female connectors attatched to the mics are a larger diameter than the ones on my akg km235 (which can be viewed here: http://www.sonicsense.com/access.htm scroll down to t-bars)

Any suggestions for a sturdy but reversible solution?

Title: Re:adapting female threads on ld mics for akg km235
Post by: Lee on February 19, 2004, 10:37:20 PM

Bill,

This is how we do it on team bama:

(http://www.cds.caltech.edu/~cxy/images/compressor/duct-tape.jpg)

Sturdy, and reversable.

Title: Re:adapting female threads on ld mics for akg km235
Post by: busknuckle on February 19, 2004, 10:48:16 PM

;D

I don't think the tape residue would look good on Jonny's 319's.

Title: Re:adapting female threads on ld mics for akg km235
Post by: Lee on February 19, 2004, 10:50:52 PM

Quote from: Bill on February 19, 2004, 10:48:16 PM
;D

I don't think the tape residue would look good on Jonny's 319's.

I'm a step ahead of ya, buddy. This will take it right off:

(http://www.wd40.es/media/images/Big-Box-Mixto-WD-40-x-200-u11.jpg)

(note: I AM NOT advocating that people use WD-40 anywhere near anyone's mics!)

Title: Re:adapting female threads on ld mics for akg km235
Post by: heath on February 19, 2004, 11:02:49 PM

:lol: +T

Title: Re:adapting female threads on ld mics for akg km235
Post by: InfiniteOhms on February 20, 2004, 12:07:50 AM

definately deserves a +T

Taperssection.com

Gear / Technical Help => Ask The Tapers => Topic started by: busknuckle on February 19, 2004, 08:26:31 PM